Playskool Showcam Pink Operating instructions

Type
Operating instructions

This manual is also suitable for

AGES 3-7
x4
ALKALINE BATTERIES
REQUIRED
1.5V AA
NOT INCLUDED
*This can only be done
before you take a photo.
Flip the switch on the side of the camera from camera mode to projector mode.
For best picture quality, place the camera approximately 24 inches from projection
surface. Images will project from camera lens when in projection mode.
There are 3 fun ways you can project your photos!
• Press for an automatic slideshow with fun sound effects.
• Press
for 1 of 5 slideshow themes based on the stamps you choose.
• Use the or arrows on to scroll through your
photos manually.
NOTE: Projection resolution is less than actual
photo resolution. For full quality photos,
download to a computer. Projected photos
appear square. Actual photos will preview
and print in rectangular landscape format.
No software required. USB cable required but
not included.
1. Slide open the USB port. Connect the small end of
the USB cable (not included) into the USB port on your
camera, and connect the large end to the USB port on
your computer.
2. The camera will appear connected to your
computer as a drive, similar to a flash drive. Drag the
drive folder to your desktop to transfer images to
your computer.
DO NOT DISCONNECT USB CABLE FROM THE
CAMERA OR THE COMPUTER WHILE THE IMAGES ARE
TRANSFERRING TO YOUR COMPUTER.
3. You can disconnect the USB cable when the stops flashing.
Note: Animations and sound effects will not transfer onto the computer.
1. Before taking a photo in camera
mode, press
.
2. Use the
or arrows to browse
through all stamps, frames, stories, and animations.
HINT: You can also press the and arrows
to quickly toggle between stamps, stories and
animations.
3. Once you find the effect you’d like to use, aim
camera and press .
ON/OFF
RESET
Press any of the
scroll
buttons to see the last photo taken.
Press
to scroll forward. Press to
scroll backward. Images will appear in
reverse chronological order. Animated
pictures will play automatically.
PROJECTor
REVIEW
DOWNLOAD
DELETE
projector
camera
While viewing any photo, press
.
When
appears, press again.
To delete ALL of your photos, press and hold for
5 seconds until appears. Press again to
delete all photos.
Change your mind? When appears,
do NOT press delete again. Wait 10
seconds or press any other button
and you will exit out of the delete
command.
You cannot delete photos in
projector mode.
STAMPS,
STORIES &
ANIMATIONS
*
Flip the switch on the side of the camera
from projector mode to camera mode.
Aim camera at your subject.
To take a photo, press .
If you’d like to take another photo,
wait 10 seconds or press again
to exit preview.
camera
PROBLEM CAUSE SOLUTION
Camera will not take a
photo
Battery power is low or
completely drained
Replace batteries with 4 x 1.5v fresh AA
alkaline batteries.
Camera is turned off Slide the power switch to the ON position or
press any button to exit standby mode.
Camera’s memory is full of
images
Download pictures to your computer or
use
to delete some of the images.
Camera will not project Battery power is low or
completely drained
Replace batteries with 4 x 1.5v fresh AA
alkaline batteries.
Mode switch is not fully engaged Make sure that mode switch is rotated all the
way to Projector Mode.
Photos are blurry Camera moved when the picture
was taken
Try to keep the camera still when you are
taking a picture.
Lens may be dirty Wipe the lens with a soft cloth.
Photos will not transfer
to the computer
USB cable may not be connected
properly
Check both the camera and computer cable
connections.
Power is not turned on Slide the power switch on the back of the
camera to the ON position.
Camera will not turn on or
functions abnormally
Battery power is low or
completely drained
Replace batteries with 4 x 1.5v fresh AA
alkaline batteries.
Buttons are frozen Press reset button.
Camera is in standby mode due
to inactivity
Press any button.
Camera freezes Minor glitch Press reset button.
File system is corrupt Connect the camera to your computer with a
USB cable (not included) while powering on.
Allow the computer to reformat the camera.
Please note that this will delete all of
your photos.
Phillips/cross head screwdriver (not
included) needed to insert batteries. Use
screwdriver to loosen screw in battery
compartment door (screws remain attached
to door). Remove door. Insert 4 x 1.5V fresh
AA batteries. Alkaline batteries are required.
Replace door and tighten screw.
To deactivate all camera sounds, press and
hold
,
and
at the same time. Hold
for 5 seconds and/or until the
icon appears.
Silence Sound Effects
TROUBLESHOOTING
BATTERY
INSTALLATION
FCC STATEMENT
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference,
and (2) this device must accept any interference
received, including interference that may cause
undesired operation.
NOTE: This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy, and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there
is no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
•Reorientorrelocatethereceivingantenna.
•Increasetheseparationbetweentheequipment
and receiver.
•Consultthedealeroranexperiencedradio/TV
technician for help.
CAUTION:Changesormodicationstothisunitnot
expresslyapprovedbythepartyresponsiblefor
compliance could void the user’s authority to operate
the equipment.
IMPORTANT: BATTERY INFORMATION
CAUTION:
1. TO AVOID BATTERY LEAKAGE
a. Always follow the instructions carefully. Use only batteries
specified and be sure to insert them correctly by matching the +
and – polarity markings.
b. Do not mix old batteries and new batteries or standard (carbon-
zinc) with alkaline batteries.
c. Remove exhausted or dead batteries from the product.
d. Remove batteries if product is not to be played with for a long
time.
e. Do not short-circuit the supply terminals.
f. RECHARGEABLE BATTERIES: Do not mix these with any other
types of batteries. Always remove from the product before
recharging. Recharge batteries under adult supervision. DO NOT
RECHARGE OTHER TYPES OF BATTERIES.
2. Should this product cause, or be affected by, local electrical
interference, move it away from other electrical equipment. Reset
(switching off and back on again or removing and re-inserting
batteries) if necessary.
©2012 Hasbro, Pawtucket, RI 02861-1059 USA. Questions? Call 1-800-PLAYSKL
Consumer Services: Hasbro UK Ltd., PO Box 43, Newport NP19 4YD UK.
00800 22427276. [email protected]; www.hasbro.co.uk.
0-3
©2012Hasbro.AllRightsReserved.TM&®denoteU.S.Trademarks.A2875/7340250000
ManufacturedbyHasbroSA,RueEmile-Boéchat31,2800DelémontCH.Represented by Hasbro
Europe,2RoundwoodAve,StockleyPark,Uxbridge,Middlesex,UB111AZ.UK. Colours and contents
mayvaryfromthoseshown.Pleaseretainthisinformationforfuturereference.MADEINCHINA.
NOTETOUKCONSUMERS:Thisproductanditsbatteriesmustbedisposedofseparately
atyourlocalwasterecyclingcentre.Donotdisposeofinyourhouseholdwastebin.
  • Page 1 1
  • Page 2 2

Playskool Showcam Pink Operating instructions

Type
Operating instructions
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI