Abocom CAS2047 User manual

Category
Modems
Type
User manual
- 1-
BroadBand Router
(with 4-Port EtherSwitch)
Quick Installation Guide
M73-APO07-390
STEP 1: CABLING
Figure 1
Cable/xDSL
modem
ISP
Internet
UTP Ethernet standard
/cross-over cable
1-1
1-2
1-3 1-3 1-3 1-3
1-1. Connect the power adapter to this product and power it on.
The LED of Power will illuminate after this step.
1-2. Apply the UTP cable to connect your Cable/DSL modem to this product’s Internet port.
The LED of Internet will illuminate after this step.
1-3. Use a network cable to connect your PCs’ Ethernet ports to one of this product’s LAN (1
to 4) ports.
The LED of LAN port you plugged into will illuminate after this step.
STEP 2: INSTALLING WIZARD
Note: To configure this device, you must have IE 4.01 or above installed.
1. Load the setup CD-ROM onto your computer. The auto-execution file will start
automatically.
2. Select Quick Setup Wizard.
3. The self-explanatory wizard will guide you through the installation procedure. Follow
the on-screen instruction to proceed.
STEP 3: CHECKING THE INTERNET CONNECTION
You can open a new web browser to surf the Internet now.
Should the access fail, you can check by the following steps:
3-1. go to 192.168.1.254;
3-2. select Network status\WAN IP Status in the left pane,
3-3. if the IP address field displays anything except 0.0.0.0, it means the Internet connection is
well established. Otherwise (as illustrated below), repeat the whole procedures.
Figure 3
.
Internet connection
is not successful.
- 2-
  • Page 1 1
  • Page 2 2

Abocom CAS2047 User manual

Category
Modems
Type
User manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI