Allied Brass PQN-93-ABR Installation guide

DRILLED HOLE

DETAIL O

MOUNTING PLATE

SET SCREW

SCREW

ANCHOR

DRILLED HOLE

Step 1:

Determine your desired location for installation and make a mark for the location of the mounting plate. Remove mounting

plate from backplate by loosening set screw in backplate as pictured below. Place center hole of mounting plate over mark

made above. Make 2 marks where mounting screws will be placed as shown below. Drill hole at each of the marks. (You may

substitute other style mounting anchors or screws if desired). Place anchors into the holes made. Place mounting plate over

holes and secure to mounting surface using screws as shown below.

Drill holes in Wall for screw anchors and attach Mounting Plate to Wall

PERSPECTIVE

BACKPLATE

PQN-93

INSTALLATION INSTRUCTIONS

No portion of this document or any artwork contained herein should reproduced in any way without the written conset of ALLIED BRASS INC.

DETAIL N

SET SCREW

MOUNTING PLATE

Step 2:

Place bracket on mounting plate and secure by tightening set screw as shown below.

Attach Bracket to Mounting Plate.

PERSPECTIVE

BACK PLATE

PQN-93

INSTALLATION INSTRUCTIONS

No portion of this document or any artwork contained herein should reproduced in any way without the written conset of ALLIED BRASS INC.