3.
Note: Do not operate the tower fan unless it is in its proper,
upright position.
7
4.
OPERATING INSTRUCTIONS
Once fan is fully assembled (see Assembly Instructions section), place
fan on a dry, level surface. Plug it into a 120V AC electrical outlet.
Controlling the Fan Speed
To operate, turn the rotary knob switch to the appropriate speed
control option. There are four available settings: 0=Off, ,3=High
4
Align the groove and arrow at the
bottom of the fan housing D to the
arrow on the base assembly which is
near the central hole edge of the base
assembly
Please make sure the three
buckles at the bottom of the fan body
connected closely to the base and all
connections between the fan body and
the base are tight and secure
( )
(
) (Fig. 3). Push the base
assembly into the fan body until a “click”
is heard.
(Fig. 4).
Locate the power cord holding bracket
at the bottom of the base assembly
Gently pull any slack out of the power
cord place the power cord securely in
the holding bracket and secure the
power cord bracket over the power
cord Then thread the power cord
through the U” locating notch on the
edge of the base assembly
“
(Fig. 5).
Stand the fan in an upright position.
2=Medium, .1=Low
5
8
Controlling Fan Oscillation
CARE AND MAINTENANCE
TO STORE: Make sure to disassemble and clean the fan before
storing. Retain the original packaging for the purpose of storing
your fan. Always store fan in a dry place. Never store it while it is
still plugged in. Never wrap the cord tightly around the fan, and do
not put any stress on the cord where it enters the fan, as it could
cause the cord to fray and break.
CAUTION: DO NOT ALLOW WATER TO RUN INTO THE INTERIOR
OF THE FAN AS THIS COULD CREATE A FIRE OR ELECTRIC
SHOCK HAZARD. THE FAN MOTOR IS FACTORY LUBRICATED
FOR LIFE AND WILL REQUIRE NO FURTHER LUBRICATION.
NO OTHER USER MAINTENANCE IS REQUIRED OR
RECOMMENDED. IF SERVICE IS REQUIRED, SEND YOUR FAN
TO THE AUTHORIZED SERVICE FACILITY.
TO CLEAN: Always disconnect the power cord from the electrical
outlet when cleaning your fan. Light accumulated dust can be
removed by using a soft cloth to wipe away the dust at the back
grille of the fan. Wipe the exterior surfaces of the fan occasionally
with a damp cloth (not dripping wet) and dry thoroughly with a soft
dry cloth before operating the fan. Do not use harsh cleaners or
materials to clean this unit. Doing so will damage the unit.
To activate or de fan oscillation, press the oscillation activate button.
ONE-YEAR LIMITED WARRANTY
The manufacturer warrants to the original purchaser that each
new
product and
service part is free
from defects in material and
workmanship and agrees to repair or replace under this warranty
any
defective product or part as follows from the original date of
purchase
for a period of one (1) year.
/
