CERAMIC HEATER EN - 1
(with IR remote control)
PCL-333 Kalahari
We thank you for the purchase of this Profile product.
Note: It is important that you read this manual carefully
before using the product. And be sure to save this
manual for possible use later.
Technical information
Mains voltage: 230V (50Hz)
Power: - In position 1 Æ 1000W
- In position 2 Æ 2000W
IP20 (no protection against water)
Overheat protection
Variable, built-in thermostat
Oscillating function
Tilt protection
Auto-off function with timer
Remote control with infrared
With handle for easy moving
Extra ON/OFF switch as protection on the rear of the
base.
Ideal for use in dry spaces to 60 m³
Safety precautions
To ensure safe operation of your heater, the appliance
must be connected in accordance with the indications
in the manual.
The appliance is only suitable for domestic use within
the home.
Do not use the appliance in humid spaces, such as
bathrooms and utility spaces.
When the heater is covered, then this can result in a
fire hazard.
Place the appliance only upright and on a level, dry
base.
The surfaces, and especially the grate, become very
hot during operation. Make sure that small children
cannot touch these surfaces.
No objects may be inserted through the appliance's
grate openings. This can disturb proper operation and
potentially lead to combustion of the object.
Never use the appliance in combination with a time
switch. The automatic operation of heaters can result
in a hazard during your absence.
The mains lead is not allowed to be run across the hot
appliance.
Electrical heaters are designed as additional heating
and are not suitable for main heating during the cold
season.
When the appliance has fallen, first disconnect the
power supply, before returning the appliance to its
upright position and if necessary remove what caused
it to fall.
Never leave your appliance unattended. Also always
pull the plug out of the socket when you leave the
room.
Do not use an extension lead.
Position the heater at a distance of at least 100cm
from obstacles and ensure that the hot air flow of the
appliance is not blown against any easily combustible
objects (such as curtains and/or heat-sensitive
plastics).
Connection
The heater is supplied with a socket plug. Never
operate the appliance with a damaged mains lead
and/or plug, or after a malfunctioning of the heater has
occurred or after it has been damaged in any possible
way.
The replacement of a mains lead and/or plug should
only be performed by a qualified expert, who is familiar
with the applicable regulations.
Operation and functions (are identical for both
manual and remote control operation)
Insert the socket plug in the wall socket and press
the switch at the rear side of the appliance.
Display:
A. 1000W + half a sun Æ appliance functions in the
lowest position.
B. 2000W + entire sun Æ appliance functions in the
highest position.
C. When the oscillating function is activated, the 2
arrows will blink.
D. Christmas tree Æ negative ion generator is
activated (= the environment air is purified through
the ionisator).
E. Room temperature.
F. Auto-off function with timer.
Push button/key "on-off":
Press the push button/key "on-off" in order to switch
the appliance off or on.
The fan will remain functioning during the switching
off until the heating element has cooled down.
Push button/key "model":
A. Set temperature:
Press the model function 1x until the temperature
blinks on the display.
A
B
C
D
E
F
CERAMIC HEATER EN - 2
(with IR remote control)
PCL-333 Kalahari
The set temperature can be adapted (between 15°C
and 35°C) by means of the + and – button.
When the room temperature is 1°C higher than the set
temperature, the heating will stop and only cold air will
be blown.
When the heater is switched off by means of the push
button/key "on-off", the set temperature will be saved
(= memory).
B. Auto-off function with timer:
Press the push button/key “model” 2x until the time
function blinks on the display.
The time can be set by using the + and – key.
After setting this automatic auto-off function, the
display will display the remaining hours until the
appliance switches off.
Push button/key "level":
When the room temperature is 1°C lower than the set
temperature, the appliance will automatically initiate at
1000W (= half a sun).
Press the level function 1x = 2000W (= full sun).
Press the level function 2x = fan function.
Push button/key "swing":
When you press the swing function, the oscillating
function will be activated or deactivated.
Cleaning
We recommend carefully cleaning the heater once a
month to remove dirt and dust. This is to allow the
heater to operate efficiently and safely.
Always switch off the appliance and pull the plug from
the wall socket. Make sure the appliance has
completely cooled down before cleaning it.
Be careful when cleaning the filter. Wash it with warm
water.
Do NOT clean the heater with petrol, thinners or other
corrosive products.
Keep the box for storage during periods that you are
not using the ceramic heater. After all, the heater must
also be kept free of dirt and dust during storage.
Problems
When the push button/key "on-off" does not function,
check whether the plug is connected to the wall
socket.
The tilt protection ensures that the power is
disconnected when the heater falls.
The remote control will not function correctly when it is
not aimed at the LCD display. Check the batteries (=
3xAAA) when the remote control still does not function
during correct usage.
The thermostat will automatically disconnect the power
when the appliance is used in warm environments.
Guarantee
The guarantee period for the PCL-333 amounts to 2
years and commences on the date of purchase.
During the guarantee period, Eltra NV will repair any
defects attributable to material or production faults.
Eltra NV may choose to either repair or replace the
defective appliance.
Eltra NV is not obliged to repair or replace appliances
if they have become defective as a result of damage,
inappropriate use, or modifications or adaptations
made after the purchase date.
Take any defective appliance together with the original
receipt back to the shop where the appliance was
purchased. Always add a note with a description of the
problem.
Damage
Eltra NV can under no circumstances whatsoever be
held responsible for damage of whatever nature if the
appliance was not correctly installed according to the
specified installation instructions, nor for damage as a
result of unforeseen circumstances, such as natural
disasters and lightening strike. All such resulting costs
are consequently at the expense of the buyer and are
not covered by the guarantee conditions.
www.profile.eu
Eltra nv, Pachtgoedstraat 2, 9140 Temse, BELGIUM
Eltra DIYeuronet, Frontstraat 14, 5405 AM Uden,
THE NETHERLANDS
/
