Profile PCL-333 Kalahari Owner's manual

Brand: Profile

Model: PCL-333 Kalahari

Type: Owner's manual

Profile PCL-333 Kalahari ceramic heater offers safe and efficient heating solutions for dry indoor spaces up to 60 cubic meters. With two power settings (1000W and 2000W), an adjustable thermostat, and an oscillation function, it provides customized warmth distribution. The built-in timer allows for automatic shutoff, while the overheat protection and tilt protection ensure safe operation. Additionally, the remote control and easy-to-read LCD display add convenience to your heating experience.

CERAMIC HEATER EN - 1

(with IR remote control)

PCL-333 Kalahari

We thank you for the purchase of this Profile product.

Note: It is important that you read this manual carefully

before using the product. And be sure to save this

manual for possible use later.

Technical information

 Mains voltage: 230V (50Hz)

 Power: - In position 1 Æ 1000W

- In position 2 Æ 2000W

 IP20 (no protection against water)

 Overheat protection

 Variable, built-in thermostat

 Oscillating function

 Tilt protection

 Auto-off function with timer

 Remote control with infrared

 With handle for easy moving

 Extra ON/OFF switch as protection on the rear of the

base.

 Ideal for use in dry spaces to 60 m³

Safety precautions

 To ensure safe operation of your heater, the appliance

must be connected in accordance with the indications

in the manual.

 The appliance is only suitable for domestic use within

the home.

 Do not use the appliance in humid spaces, such as

bathrooms and utility spaces.

 When the heater is covered, then this can result in a

fire hazard.

 Place the appliance only upright and on a level, dry

base.

 The surfaces, and especially the grate, become very

hot during operation. Make sure that small children

cannot touch these surfaces.

 No objects may be inserted through the appliance's

grate openings. This can disturb proper operation and

potentially lead to combustion of the object.

 Never use the appliance in combination with a time

switch. The automatic operation of heaters can result

in a hazard during your absence.

 The mains lead is not allowed to be run across the hot

appliance.

 Electrical heaters are designed as additional heating

and are not suitable for main heating during the cold

season.

 When the appliance has fallen, first disconnect the

power supply, before returning the appliance to its

upright position and if necessary remove what caused

it to fall.

 Never leave your appliance unattended. Also always

pull the plug out of the socket when you leave the

room.

 Do not use an extension lead.

 Position the heater at a distance of at least 100cm

from obstacles and ensure that the hot air flow of the

appliance is not blown against any easily combustible

objects (such as curtains and/or heat-sensitive

plastics).

Connection

The heater is supplied with a socket plug. Never

operate the appliance with a damaged mains lead

and/or plug, or after a malfunctioning of the heater has

occurred or after it has been damaged in any possible

way.

The replacement of a mains lead and/or plug should

only be performed by a qualified expert, who is familiar

with the applicable regulations.

Operation and functions (are identical for both

manual and remote control operation)

 Insert the socket plug in the wall socket and press

the switch at the rear side of the appliance.

Display:

A. 1000W + half a sun Æ appliance functions in the

lowest position.

B. 2000W + entire sun Æ appliance functions in the

highest position.

C. When the oscillating function is activated, the 2

arrows will blink.

D. Christmas tree Æ negative ion generator is

activated (= the environment air is purified through

the ionisator).

E. Room temperature.

F. Auto-off function with timer.

Push button/key "on-off":

 Press the push button/key "on-off" in order to switch

the appliance off or on.

 The fan will remain functioning during the switching

off until the heating element has cooled down.

Push button/key "model":

A. Set temperature:

 Press the model function 1x until the temperature

blinks on the display.

CERAMIC HEATER EN - 2

(with IR remote control)

PCL-333 Kalahari

 The set temperature can be adapted (between 15°C

and 35°C) by means of the + and – button.

 When the room temperature is 1°C higher than the set

temperature, the heating will stop and only cold air will

be blown.

 When the heater is switched off by means of the push

button/key "on-off", the set temperature will be saved

(= memory).

B. Auto-off function with timer:

 Press the push button/key “model” 2x until the time

function blinks on the display.

 The time can be set by using the + and – key.

 After setting this automatic auto-off function, the

display will display the remaining hours until the

appliance switches off.

Push button/key "level":

 When the room temperature is 1°C lower than the set

temperature, the appliance will automatically initiate at

1000W (= half a sun).

 Press the level function 1x = 2000W (= full sun).

 Press the level function 2x = fan function.

Push button/key "swing":

 When you press the swing function, the oscillating

function will be activated or deactivated.

Cleaning

 We recommend carefully cleaning the heater once a

month to remove dirt and dust. This is to allow the

heater to operate efficiently and safely.

 Always switch off the appliance and pull the plug from

the wall socket. Make sure the appliance has

completely cooled down before cleaning it.

 Be careful when cleaning the filter. Wash it with warm

water.

 Do NOT clean the heater with petrol, thinners or other

corrosive products.

 Keep the box for storage during periods that you are

not using the ceramic heater. After all, the heater must

also be kept free of dirt and dust during storage.

Problems

 When the push button/key "on-off" does not function,

check whether the plug is connected to the wall

socket.

 The tilt protection ensures that the power is

disconnected when the heater falls.

 The remote control will not function correctly when it is

not aimed at the LCD display. Check the batteries (=

3xAAA) when the remote control still does not function

during correct usage.

 The thermostat will automatically disconnect the power

when the appliance is used in warm environments.

Guarantee

The guarantee period for the PCL-333 amounts to 2

years and commences on the date of purchase.

During the guarantee period, Eltra NV will repair any

defects attributable to material or production faults.

Eltra NV may choose to either repair or replace the

defective appliance.

Eltra NV is not obliged to repair or replace appliances

if they have become defective as a result of damage,

inappropriate use, or modifications or adaptations

made after the purchase date.

Take any defective appliance together with the original

receipt back to the shop where the appliance was

purchased. Always add a note with a description of the

problem.

Damage

Eltra NV can under no circumstances whatsoever be

held responsible for damage of whatever nature if the

appliance was not correctly installed according to the

specified installation instructions, nor for damage as a

result of unforeseen circumstances, such as natural

disasters and lightening strike. All such resulting costs

are consequently at the expense of the buyer and are

not covered by the guarantee conditions.

www.profile.eu

Eltra nv, Pachtgoedstraat 2, 9140 Temse, BELGIUM

Eltra DIYeuronet, Frontstraat 14, 5405 AM Uden,

THE NETHERLANDS

Profile PCL-333 Kalahari Owner's manual

Profile PCL-333 Kalahari Owner's manual

Profile PCL-333 Kalahari Owner's manual

Related papers

Other documents