![](//vs1.manuzoid.com/store/data-gzf/b8e6426aeacc3df7c69e3d4fcbc3f65c/2/001119887.htmlex.zip/bg2.jpg)
1 2
How to install Adjustments
Warning!
It is advisable to have an Öhlins dealer install the
shock absorber.
When installing, consult your Vehicle Service
Manual.
1
Raise the front end of the vehicle so that
the original shock absorbers are in a neutral
position.
Warning!
Make sure the vehicle is securely supported so
that it will not tip.
2
Remove the original shock absorbers.
Note!
Before installing the Öhlins shock absorber clean
the vehicle thoroughly.
3
Install the Öhlins shock absorbers in the
same positions as the original units. Fasten
the upper attachment rst. The piggy back
reservoirs should be at the top and facing
outwards.
1
4
Fasten the lower attachment. Raise or lower
the wheels slightly to make the attachment t.
5
Tighten the attachment screws to the correct
torque. Consult your ATV Owners manual.
6
Check sag and ride height according to the
Öhlins owners manual. See also Set-up data
in this folder.
Caution!
Make sure that all screws are tightened to the
correct torque and that nothing fouls or restricts
movement of the shock absorber when the
suspension is fully compressed or extended.
3
4
Set-up Data
Warning!
Before riding, always make sure that the
basic settings made by Öhlins are according
to recommended Set-up Data. Read about
adjustments and setting up in the Öhlins
Owner’s Manual before you make any
adjustments. Contact an Öhlins dealer if you
have any questions about setting up the shock
absorber.
Öhlins Shock Absorber S36PR1C2Q1 HO 876
Spring Preload
Adjuster
Recommended set-up
Rebound 20 clicks
Compression
Low speed 15 clicks
High speed 1½ turns
Shock Absorber Data
Length 504 mm
Stroke 143 mm
Free Sag and Ride Height
Free sag, front 60±5 mm
2½±¼’’
Free sag, rear 30±5 mm
1¼±¼’’
Ride height, front 80±5 mm
3¼±¼’’
Ride height, rear 105±5 mm
4½±¼’’
Rebound
Damping Adjuster
Compression
Damping Adjuster
- Low speed
- High speed
Cross
over
Spring platform
00154-02
Sleeve
03281-01
Washer
00115-01
Circlip
00131-01
Short spring stroke adjuster
- Cross over
The total spring characteristics can be
adjusted by moving the spring platforms
on the oating sleeve. The spring platform
position decides when the stroke for the short
spring is blocked. At this point, the total spring
stiffness will increase on compression stroke.
Lock the spring platforms against each other
using C-spanners.