Ohlins 21049-34 Mounting Instruction

Compression adjuster for TTX44 MX-shock

Dual compression adjuster

Mounting Instructions

Kit Contents

Part No. Pcs.

Adjuster 21049-34 1

See setting bank for shim setting.

Recommended start click position:

Low speed 12 clicks

High speed position 2

Set-up Data

Part no. 21049-34

Issued 2011-03-07

Warning!

There is high pressure inside the shock absorber, do not

try to open or disassemble compression adjuster or any

other part of the shock absorber.

Warning!

Changing compression adjuster shall only be performed

by an autorized Öhlins service centre. The installation

procedure requires special knowledge and certain tools.

Öhlins Racing AB

Box 722

S-194 27 Upplands Väsby, Sweden

Phone +46 8 590 025 00

fax +46 8 590 025 80

reserved. Any reprinting or

unauthorized use without the written

permission of Öhlins Racing AB

is prohibited.

www.ohlins.com

Öhlins products are subject to continuous improvement and

development, therefore, although these instructions include the

most up-to-date information available at the time of printing,

minor updates may occur.

To ﬁnd the latest information contact your Öhlins distributor.

Please consult your Öhlins dealer if you have any questions

regarding the contents in this document.

Tightening torque

Housing hexagon 17mm, torque 12Nm

Lock nut, use tool 01863-02, torque 25Nm