2. Bush
  3. Small
Small

Bush Small, 7438606, SMALL BTS SILVER, Small Wireless Speaker User manual

  • Hello! I am an AI chatbot trained to assist you with the Bush Small User manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Instruction manual
Bluetooth Speaker BT860S
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the
Troubleshooting
You’ll soon be enjoying your new Bluetooth Speaker.
It all begins here, with your instructions. Don’t worry, there’s
nothing too technical coming up. Just simple, step-by-step
guidance to get you up and running quickly. Sound good? Then
let’s get started.
Help and Guidance
We’re here to help you get the most from your Bluetooth speaker. Should you require any
guidance, a simple solution can often be found online at:
www.argos-support.co.uk
If you still require further assistance, call one of our experts on 0345 600 3021.
3
section of these instructions, or online at www.argos-support.co.uk If you still require further assistance, call one of our experts on 0345 600 3021.
Contents
1
Safety information
General safety information 6
Power source 6
Moisture and water 6
Ventilation 7
Heat sources and flames 7
2
Getting to know your Bluetooth speaker
Positioning the Bluetooth speaker 12
Power connection 12
3
Using your Bluetooth speaker
Power on 16
Connect to a Bluetooth device 16
Adjusting the volume 17
Listening to Music/Audio using Bluetooth 18
Using as a Mobile handsfree speakerphone 18
Aux in mode 19
4
Other information
Technical specification 22
5
Product support
Troubleshooting 26
Help and assistance 27
Disposal 28
Your Bush Guarantee 29
This page is left intentionally blank
1Safety information
Safety information6
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the
Troubleshooting
Safety information
Important - Please read these instructions fully before
installing or operating
General safety information
Keep the product and all its parts out of reach of small children.
This product is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have
been given supervision or instruction concerning the use of the appliance by a person
responsible for their safety.
• Do not attempt to open the product. This product does not contain any user
serviceable parts. Unauthorised handling of the device may damage it and will void
your warranty.
• Do not use your Bluetooth speaker near emergency/intensive care medical
equipment; if you have a pacemaker fitted or during an electrical storm.
To avoid possible hearing damage, do not listen to this Bluetooth speaker at
high volume levels for long periods of time. Always keep the volume within
reasonable limits.
Power source
Only use the USB charging cable that came with the product. Using an unauthorised
charging cable will invalidate your guarantee and may irrecoverably damage the product.
Please charge the integral lithium battery in your Bluetooth speaker at least once a month,
to prevent damage to and prolong the life of the lithium battery.
Moisture and water
• Do not leave it in low temperatures as moisture can form inside the product, which
may damage the circuit board.
Safety information
Important - Please read these instructions fully before
installing or operating
Safety information
7
section of these instructions, or online at www.argos-support.co.uk If you still require further assistance, call one of our experts on 0345 600 3021.
Ventilation
• Do not block or cover slots, holes or openings on the product by placing on soft
furnishings such as carpets, rugs or beds as these are provided for functionality and/or
ventilation to ensure safe operation of the product.
Heat sources and flames
Do not leave it in high temperatures as electronic devices and plastic parts may warp in
heat.
This page is left intentionally blank
2
Getting to know your Bluetooth
speaker
10
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the
Troubleshooting
Getting to know your Bluetooth speaker
Getting to know your Bluetooth speaker
You’ll be up and running in no time
Ready? Let’s begin...
Please read these instructions carefully. They contain important information which will
help you get the best from your product and ensure safe and correct installation and
operation.
If you require any further assistance, our technical experts are happy to help. For full
details, refer to the product support section at the end of these instructions.
Fig 3.
1 2 3
11
section of these instructions, or online at www.argos-support.co.uk If you still require further assistance, call one of our experts on 0345 600 3021.
Getting to know your Bluetooth speaker
Getting to know your Bluetooth speaker
You’ll be up and running in no time
1. Aux in
2. Micro USB socket
3. On/Off switch
4. Battery charging LED (Red)/Bluetooth LED (Blue)
5. Volume -
6. Bluetooth mode:
• Play/pause
Mobile handsfree:
• Answer/End a call
7. Volume +
8. Microphone
Fig 4.
4 5 6 7 8
12
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the
Troubleshooting
Getting to know your Bluetooth speaker
Getting to know your Bluetooth speaker
You’ll be up and running in no time
Positioning the Bluetooth speaker
It is important that you consider carefully in advance where your Bluetooth Speaker will be
situated and make sure that it is:
• on a flat and stable surface.
• at least 1 metre away from other electrical appliances to avoid interference.
• where it will be in range of the connected or ‘paired’ bluetooth device (e.g. iPod/
iPhone/iPad/Android/other phone/computer, which is about 10 metres or less (33 feet
or less) in line of sight.
• Never place your Bluetooth Speaker directly onto antique or polished surfaces.
Power connection
1. Connect the micro USB end of the charging cable (supplied) to the USB socket under
the rubber cover on the back of the Bluetooth speaker. Plug the standard end of the
USB charging cable into a computer or other USB charging device.
2. The red battery charging LED on the top of the Bluetooth speaker will light up, to
indicate that the battery is charging. When the battery is fully charged the red LED will
turn off.
3. Note: It will take approximately 2.5 hours to fully charge your Bluetooth Speaker,
before first use.
4. When fully charged, unplug the micro USB charging cable.
Note: Your Bluetooth speaker has an approximate play time of 5 hours, before it needs
to be recharged. When the battery power is low, you will hear an audible alert every 5
seconds. You should plug in and recharge your Bluetooth speaker straight away.
This page is left intentionally blank
section of these instructions, or online at www.argos-support.co.uk If you still require further assistance, call one of our experts on 0345 600 3021.
This page is left intentionally blank
3
Using your Bluetooth
speaker
16
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the
Troubleshooting
Using your Bluetooth speaker
Using your Bluetooth speaker
Let’s get started
Power on
Slide the Power switch under the rubber cover on the back of the product to on. Your
Bluetooth speaker will switch on in Bluetooth mode. A tone will sound and the blue LED
on the top of the product will flash quickly whilst your product searches for Bluetooth
devices.
Standby mode
If the Bluetooth speaker does not receive an audio signal for approximately 15 minutes
it will go to Standby mode and the blue Bluetooth LED will flash slowly. Press and hold
the Play/Pause button to turn the product back on again. Alternatively you can slide the
power switch on the back of the product to off and then on again.
Power o
Slide the Power switch under the rubber cover on the back of the product to off.
Note: You will not be able to power off your Bluetooth speaker when you are charging
the battery. The red charging LED will remain on until the battery is fully charged.
Connect to a Bluetooth device
1. The blue LED on the top of the product will flash quickly whilst your product searches
for Bluetooth devices.
2. On the device that you would like to connect to your Bluetooth speaker via Bluetooth
(e.g. iPhone/iPad/Android/other phone/Tablet/Computer), turn on Bluetooth
connectivity and ensure that it is ‘discoverable’.
Note: If necessary, refer to the instructions for your device to add or set up Bluetooth.
3. Select to ‘Add new device’, if necessary.
Note: Some products will automatically search for a new device and so the ‘Add new
device’ option is not available.
17
section of these instructions, or online at www.argos-support.co.uk If you still require further assistance, call one of our experts on 0345 600 3021.
Using your Bluetooth speaker
Using your Bluetooth speaker
Let’s get started
4. When found, your Bluetooth speaker will be displayed as ‘BUSH BT860S’. Select the
device name to begin pairing.
Note: If your device requests a password, please enter ‘0000’ to complete the device
pairing.
5. When pairing is complete the blue LED will change to flash slowly.
6. Now that you have paired your device with the Bluetooth speaker, it will connect to it
when it is within range, which is about 10 metres or less (33 feet or less), line of sight.
7. Your device will remain paired with the Bluetooth speaker unless you decide to
disconnect or ‘unpair’ it.
Note: You can press and hold the button to unpair your current device and search
for new devices.
Adjusting the volume
Vol-
• Press and release to decrease the volume in steps.
• Press and hold to progressively decrease the volume.
Vol+
• Press and release to increase the volume in steps.
• Press and hold to progressively increase the volume.
Note: You will hear an audible alert when the minimum or maximum volume level has
been reached.
18
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the
Troubleshooting
Using your Bluetooth speaker
Using your Bluetooth speaker
Let’s get started
Listening to Music/Audio using Bluetooth
In Bluetooth mode:
1. Select and start the music or audio that you wish to listen to on your paired Bluetooth
device, it will now be heard through the Bluetooth speaker. Adjust the volume on the
connected device and/or your Bluetooth speaker
2. You can use the controls on your paired Bluetooth device as well as those on your
Bluetooth speaker.
• Play/Pause: Press and release to play/pause.
Using as a Mobile handsfree speakerphone
If your mobile phone supports the Hands Free Profile (HFP) or Headset Profile (HSP)
you can pair it with your Bluetooth speaker and use it as a handsfree speaker when it
is in Bluetooth mode. Follow the steps on page xx to pair your mobile phone with the
Bluetooth speaker.
Note: If your mobile supports both the HFP and HSP profiles, set it to HFP.
Make an outgoing call:
1. Dial the number as usual on your mobile phone, you will be able to hear the progress
of the call and your caller through your Bluetooth speaker and your caller will also be
able to hear you.
2. Press and release the button on the Bluetooth speaker to end the call, or end the
call as usual on your mobile phone.
Receive an incoming call:
1. Press and release the button on your Bluetooth speaker or answer the call as usual
on your mobile phone. You will be able to hear your caller through your Bluetooth
speaker and your caller will also be able to hear you.
2. Press and release the button on the Bluetooth speaker to end the call, or end the
call as usual on your mobile phone.
19
section of these instructions, or online at www.argos-support.co.uk If you still require further assistance, call one of our experts on 0345 600 3021.
Using your Bluetooth speaker
Using your Bluetooth speaker
Let’s get started
Note: If you were listening to music when you receive or make a call, the music will be
paused whilst the call is in progress and will resume once the call ends.
Aux in mode
1. Connect one end of a 3.5mm audio cable (not supplied) to the headphone (or
auxiliary out) socket of your secondary device. Connect the other end to the Aux in
socket under the rubber cover on the back of your Bluetooth speaker. This will switch
your bluetooth speaker to Aux in mode.
2. Press the Play button on your external device to start playback through the Bluetooth
speaker.
3. To gain optimal volume levels, adjust the volume level on both the secondary device
and on the Bluetooth speaker.
Note: After you have finished listening to your external device you must unplug the
audio cable from the Aux in socket, to be able to use it as a Bluetooth speaker again.
This page is left intentionally blank
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
/