Waterpik WF-04CD012-3 Quick start guide

WF-04CD012-3
Waterpik
Brand
Waterpik
Model
WF-04CD012-3
Type
Quick start guide

This manual is also suitable for

Waterpik WF-04CD012-3 is a dental water flosser that aids in maintaining good oral hygiene. Fill the reservoir with warm water, slide the pressure to high, point the tip into the sink, and turn the power ON until water flows. Then, place the tip in your mouth and close your lips enough to prevent splashing. Turn the power ON and allow water to flow from your mouth into the sink, increasing pressure to your liking. Aim the water at the gumline at a 90-degree angle, follow the gumline, and pause briefly between teeth.

Waterpik WF-04CD012-3 is a dental water flosser that aids in maintaining good oral hygiene. Fill the reservoir with warm water, slide the pressure to high, point the tip into the sink, and turn the power ON until water flows. Then, place the tip in your mouth and close your lips enough to prevent splashing. Turn the power ON and allow water to flow from your mouth into the sink, increasing pressure to your liking. Aim the water at the gumline at a 90-degree angle, follow the gumline, and pause briefly between teeth.

©2018 Water Pik, Inc.
SIDEKICK
™
This device is compatible with voltages of 100 – 240 VAC, 50/60 Hz
Water Floss
B. Assemble unit
as shown.
A.
Connect power cord to
power supply and to base
unit. Plug into electrical
outlet.
A. Slide to lowest
pressure setting.
C.
Fill reservoir with warm water and
place it firmly on the base. Slide pressure
to high, point tip into sink, turn power
ON until water flows. Turn power OFF.
B.
Place tip in mouth and close lips
enough to prevent splashing. Turn power
ON allowing water to flow from mouth into
the sink. Increase pressure to your liking.
C.
Aim water at the gumline at
a 90 degree angle. Follow the
gumline and pause briefly
between teeth.
Fill
Power
Power
For a how-to video, product
registration, and additional support
visit waterpik.com/WelcomeWF
Step 2
Unit Prep
Step 1
Quick Start Guide –
WF-04
Low
High
High
GUÍA DE INICIO RÁPIDO – WF-04
FN 20025068-F AB
Para ver un video práctico, registrar
el producto y recibir apoyo adicional,
visite waterpik.com/WelcomeWF
SIDEKICK
™
Este dispositivo es compatible con voltajes de 100–240 VCA, 50/60 Hz
Irrigación
bucal
B. Ensamble la unidad
como se muestra.
A. Conecte el cable de
alimentación a la fuente de
alimentación y a la base de
la unidad. Enchufe en el
tomacorriente.
A.
Deslice hasta la
configuración de
presión más baja.
C. Llene el depósito con agua tibia y
colóquelo firmemente en la base. Deslice la
presión a alta, apunte la boquilla hacia el
lavabo y encienda la unidad (ON) hasta que
fluya el agua. Apague la unidad (OFF).
B.
Coloque la boquilla en la boca y cierre los
labios lo suficiente para evitar salpicaduras.
Encienda la unidad (ON) permitiendo que el
agua fluya de la boca al lavabo. Aumente la
presión a su gusto.
C.
Apunte el agua hacia la línea de la
encía en un ángulo de 90 grados. Siga
la línea de la encía y haga una pausa
breve entre los dientes.
Llenado
Energía
Energía
Paso 2
Preparación
de la unidad
Paso 1
Baja
Alta
Alta
  • Page 1 1
  • Page 2 2

Waterpik WF-04CD012-3 Quick start guide

WF-04CD012-3
Waterpik
Brand
Waterpik
Model
WF-04CD012-3
Type
Quick start guide
This manual is also suitable for

Waterpik WF-04CD012-3 is a dental water flosser that aids in maintaining good oral hygiene. Fill the reservoir with warm water, slide the pressure to high, point the tip into the sink, and turn the power ON until water flows. Then, place the tip in your mouth and close your lips enough to prevent splashing. Turn the power ON and allow water to flow from your mouth into the sink, increasing pressure to your liking. Aim the water at the gumline at a 90-degree angle, follow the gumline, and pause briefly between teeth.

Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

in other languages

Related papers

Other documents