Wireless Media Player
Installation Guide
Getting started
Important Information Regarding Set-Up
If your player was previously connected via WiFi, you will need to
connect it via WiFi again. If your previous media player was connected
via coaxial cable or Ethernet cable, it will need to be connected via
coaxial cable or Ethernet. There is a limit of two devices maximum that
can be connected by WiFi in your home.
1. Plug one end of the power supply in to the new player and the other
end in to an electrical outlet. Attach the HDMI cord to the Media Player
and the TV (using your existing HDMI cord). Allow it to boot up to the
Main Menu.
2. Scroll and select Wireless Network Status from the main menu.
3. Click on Connect using WPS.
PT V_SIG_08.2018
4. Go to the Gateway (not the Media Player) and press the WPS button
on the back, as circled below.
5. If you have an Enhanced Wireless Modem from Northwestel (Hitron),
press the WPS button located on the front of your modem, as circled
below. If you don’t, skip to the next step.
6. Return to the TV where you installed the new Media Player and wait for
the system to reboot.
Still have questions?
If you require additional support, please call 1 888 423-2333 and press 1.
/