2. Heat & Glo
  3. TIARA I-B Owners Addenum

Heat & Glo TIARA I-B Owners Addenum Install Manual

  • Hello, I'm a chat assistant and I've had the opportunity to review this addendum to the owner's manual for the Tiara I-B. It provides instructions to correctly remove the burner during a LP conversion. Specifically, it emphasizes that the burner and burner pan should be removed as a single unit. I'm ready to answer any questions you may have about this process.
  • What does this document concern?
    What is the correct way to remove the burner?
    What was the incorrect method listed in the Tiara I Owner's Manual?
7014-158B 1/10 Page 1 of 1
20802 Kensington Blvd.
Lakeville, MN 55044
A Division of Hearth & Home
Technologies, Inc.
LP CONVERSION INSTRUCTIONS
BURNER REMOVAL
Page 24 of the Tiara I Owner’s Manual, drawing (Figure 6.1)
is showing to remove the burner screws. This separates the
burner from the burner pan. This is incorrect.
Remove the outer screws and then remove the burner and
burner pan as one unit.
ADDENDUM TO OWNER’S MANUAL
TIARA I-B
KEEP WITH
YOUR MANUAL
Remove 2 screws and remove burner and
burner pan as one unit.
INCORRECTCORRECT
/