Garden Oasis D71 M12206 Owner's manual

  • Hello! I am an AI chatbot trained to assist you with the Garden Oasis D71 M12206 Owner's manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
OWNERS
MANUAL
Date of purchase: _____/ _____/ _____
Grandview 3 PC
Bistro Set
Product code: D71 M12206
UPC code: 769455 761163
1
Vendor Item: AS-I-138-2NS/3
PARTS
Read through all the instructions before beginning assembly. Unpack and identify all the parts.
Place them on a flat, non-abrasive surface. Assembly by two people is recommended.
F (1)
Metal
Center Ring
ACCESSORIES
Ga (1 spare)
Bolt
Gc (1 spare)
Metal Washer
Ge (1 spare)
Glass Bumper
2
E (3)
Leg (1 Metal Washer and
1 Bolt attached for each)
A (2)
Swivel Top
Gb (3)
Screw
B (2)
Swivel Base
C (2)
Center Post
D (1)
Tempered Glass
Tabletop
Gd (1)
Allen Wrench
Gf (1)
Assembly
Instructions Sheet
ASSEMBLY INSTRUCTIONS
Place the swivel base (B) on a flat surface,
and insert the center post (C) into the hole
located at the center of the base (B). See
Fig. 1. Push the center post (C) down firmly
and twist it left and right as necessary.
Repeat procedure for the other swivel.
Align the connector of the swivel top (A)
with the hole in center post and push the
swivel top down firmly until fully engaged.
See Fig. 2.
1
2
3
CARE INSTRUCTIONS
Wash with a mild solution of soap and water; rinse thoroughly. Dry completely. Do not use bleach or solvents.
Cover furniture with outdoor furniture covers when not in use.
3
Place the tempered glass tabletop (D) upside
down on your non-abrasive work surface. Remove
all bolts (Ga) and metal washers (Gc) from legs (E).
Insert three legs (E) into the plastic receivers on
tabletop (D), working the legs in until the holes
in the leg line up with the holes in the receivers.
Place the center ring (F) between three legs. Line
up the holes and for each hole insert a bolt (Ga)
through a metal washer (Gc), through the center
ring (F) and secure into the legs (E). See Fig. 3.
Do not tighten completely.
Now go back and securely tighten all of the
bolts. Turn the table over.
Your bistro set is now ready for use.
SWIVEL ASSEMBLY
TABLE ASSEMBLY
4
5
6
Fig. 1
Fig. 2
Insert a screw (Gb) through each receiver
and secure into the tip of the leg. See Fig. 4.
7
See our extensive assortment of outdoor living products
on-line at www.sears.com and www.kmart.com
Made in / Hech en CHINA
Distributed by Sears, Roebuck and Co., Hoffman Estates, IL 60179
sears.com
For questions or comments about product:
Call toll-free:
800-457-4652
Please refer to part numbers when reordering
Gc
Ga
F
F
D
E
Gb
E
B
C
B
A
Fig. 4
Fig. 3
4
/