Bauknecht WLE 1015 Program Chart

WLE 1015
Bauknecht
Brand
Bauknecht
Model
WLE 1015
Category
Fridges
Type
Program Chart

This manual is also suitable for

PRODUCT SHEET
GB
ROBGRUSHSKCZPLFINDKNSGRIPENLFGBD
A. Display indicating the set temperature. If the
display indicating the set temperature blinks,
contact the After-sales Service.
B. Stand-by/On-Off button
C. Temperature selection button.
D. Light switch
REFRIGERATOR COMPARTMENT
CONTROLS
(depending on the model)
1. Plug in the appliance
2. The appliance is normally factory set for
operation at a temperature of 12°C. If display A
shows only an illuminated dot (stand-by mode),
press the On/Off button B
3. The product has an internal light that switches
on automatically when the door is opened
(models with metal door) or it can be turned on
and off when needed by pressing button D
located on the control panel (models with glass
door)
4. If the appliance is not to be used for a prolonged
period, it can be switched off by pressing the
stand-by/On-Off button B or by unplugging it.
STARTING UP THE APPLIANCE
The appliance is normally factory set for optimum
operation at a temperature of +12°C.
To adjust the internal temperature between +8°C
and +16°C, proceed as follows:
• Press button C once to adjust the internal
temperature: the digital display will blink,
showing the temperature previously set.
• Each time the button is pressed, the
temperature setting is changed by 1°C: the value
(between +8°C and +16°C) blinks cyclically on
the display.
• Approximately 5 seconds after the button has
been pressed for the last time, the set
temperature is stored and the digital display
stops blinking.
Note: In the event of a power failure, selected
functions remain stored in the memory.
ADJUSTING THE REFRIGERATOR
TEMPERATURE
When the bulb is faulty or broken, request a
replacement from our authorised personnel
(After-Sales Service).
REPLACING THE BULB (models with glass door)
Always disconnect the appliance from the
power supply before replacing the bulb.
1. Loosen the screw and remove the lamp cover.
2. When replacing the bulb, bear in mind that this
appliance is fitted with a special bulb (15W with
bayonet fitting); to replace do not unscrew, but
pull towards the inside of the appliance
(as indicated by the arrow).
3. Refit the lamp cover and secure it with the
screw.
REPLACING THE BULB (models with glass door)
5019 611 01008
Printed in Italy 04/09
ROBGRUSHSKCZPLFINDKNSGRIPENLFGBD
  • Page 1 1
  • Page 2 2

Bauknecht WLE 1015 Program Chart

WLE 1015
Bauknecht
Brand
Bauknecht
Model
WLE 1015
Category
Fridges
Type
Program Chart
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents