INSTRUCTION MANUAL
Wet and Dry
Model AFV67A
Wet and Dry Diagram
2
Important Safeguards
1. Please do not use the vacuum cleaner near
any liquid or gas which is flammable
or explosive to avoid injury.
2. Before you plug in / out, turn off
the power to avoid fire or get an
electric shock.
3. Please do not touch the plug when your
hands are wet to avoid getting an electric
shock.
4. Please do not plug up the vent in
order to avoid damaging the machine
as the temperature may get too high.
5. Do not vacuum the following
objects: Non-extinguished
cigarettes, gas, kerosene, and
other objects which may be
flammable, explosive or volatile.
6. Do not pick up sharp objects.
7. Avoid vacuuming print toner, lime
powder, gypsum and the like as it may
damage your vacuum’s motor.
8. During use, there is a slight chance
that the tube or machine could
generate electricity so please take
extra care.
9. Be careful not to tip your appliance in order to avoid water going into the vacuum’s
10. Warning: Do not use this product as water pump to avoid damaging the
machine.
11. When cleaning the appliance or not in use, turn off the power and plug out.
12. Please do not put the appliance under the sun or other high-temperature places
to avoid the plastic deforming.
13. The tube should not be stretched excessively or it may damage the tube.
14. Do not immerse or rinse the container in water to avoid electrical components
getting wet which may cause accidents. To clean, use a soft and moist cloth to wipe
the surface.
How to Install
A. Linking up the tube and the
Vacuum cleaner:
Insert the tube connector into the
cleaner and then rotate it clockwise until
it locks.
To disconnect: Simply rotate it
counter-clockwise
.
B. To use the blowing
function:
Insert the main suction pipe
into the blowing port then rotate it
clockwise until it locks.
C. Connecting hand lever and
long link pipe:
Contact joint: insert one end of the
tube into the long link pipe's inside
diameter, then rotate it clockwise until
it's tight.
To disconnect: Hand both ends of
the long link pipe, rotate it
counter-clockwise until it's out.
How to Use
Accessories
1. Power on
Insert the plug into the
socket.
Turn on the switch.
2. Air register
Adjust the suction by opening the air
register block. The suction will then gradually
decrease. Once you close it, the suction will
gradually increase.
Small brush is suited for
corners and tight areas, as
well as windows, tables, etc.
Great for dusting.
Floor brush is perfect for carpets
and floor.
Flat suction nozzle is suited for
crevices and corners.
Blowing Port is perfect for blowing out
dust from the crevice of the machine.
Special Instructions
1. When the water in the barrel is full, suction will stop. To restart suction: first cut off
the electricity and throw out the water. Then turn the machine on. It will work normally
again.
2. Only connect to a proper 220- 240 volt / 50 Hz socket.
3. If the supply cord is damaged, it must be replaced by the manufacturer or its service
agent to avoid a hazard.
4. This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning use of the appliance by a
person responsible for their safety.
5. Children should be supervised to ensure that they do not play with the appliance.
6. The plug must be removed from the socket before cleaning or maintaining the
appliance.
Maintenance Method
1. Dust container should be emptied when full, otherwise the vacuum will not function
well. To clean: turn off the power supply and clear the rubbish inside container.
2. Take out of the filter bag, clear the dust from inside the dust container. Filter bags
must be thoroughly cleaned with clean, warm water. If necessary, you can use neutral
cleaning detergents.
3. Put the filter bag back to its original position.
Voltage Rating: 220-240V~
Rated Frequency: 50Hz
Rated Input Power: 800W/1000W
Maximum Suction: 16kpa
/
