Whirlpool PM05016 User guide

Page is loading ...

22

Overall dimensions

Warning

- Prior to installing the electronic mixer control unit,drain pipes completely

- Generally approved technical regulations are to be complied with (EN806)

ENGLISH

23

First switch on

Once the power supply has been connected, check that the green led on the connector side of

the control unit remains lit for more than 5 seconds.

If it remains lit: correct installation.

If it does not light up: no mains power supply and the batteries are at or missing, check power

supply unit and battery connections.

If it ashes with a short ash and a long pause: battery operated, check power supply unit

connection.

If it ashes with a long ash and a short pause: batteries are being recharged, wait for 36

hours and replace batteries if ashing continues.

Note: The batteries (5) are only to be used in the event of a power failure; always use

rechargeable AA NIMH 2000mAh minimum batteries.

Technical Data

Electrical

Power supply Wall-Plug - 100-240 Vac ; 50-60 Hz

Control unit 9VDC= 1A

Humidity range (for power supply only) 10-90%

Room temperature 0-40°C

IP protection rating IPX5 (Control unit) IPX0 (Power supply)

Backup batteries (5)

►battery life

NIMH tipo AA 1.2V - 2000mAh (min.)

► 120 h with tap on stand-by

► 15 h of operation with tap on

Electrical consumption

Operating mode (mA) (W) @ 9VDC

Tap off 10 0.09

Tap on 20 0.18

Flow rate control or mixing mode (peak) 1200 10.8

ENGLISH

24

Technical Data

Hot and cold water pressure 50-500 kPa (0.05-0.5 MPa)

Hot water Max. temperature 80°C

Cold water Min. temperature 5°C

Test pressure 1 MPa

Hydraulics

Free ow rate outlet - Inlet pressure: 300 kPa (0.3 MPa)

Regulation level Flow rate (l/min)

1 2

2 4

3 6

4 9

5 12

6 15

7 18

8 21

9 24

Hydraulics

Water temperature outlet

- Inlet pressure: 300 kPa (0.3 MPa)

- Hot water inlet: 60°C

- Cold water inlet: 20°C

Regulation level Temperature (°C)

1 20

2 28

3 32

4 36

5 38

6 40

7 42

8 44

9 48

10 52

11 60

Validation of ecological compliance:

EC - this product conforms to the ecological provisions of the EU directives on the subject.

ENGLISH

25

Failure - Cause - Solution

Failure / Fault Possible cause Remedy

No water running? - Filter valves closed

- Filter valves clogged

- Hoses twisted/kinked

- Power supplier / socket

faulty

- Power supply faulty

- Connecting cable/connector

between the knob and con-

trol unit faulty/damaged

- Control knob faulty/blocked

- Electronic device faulty

- Open lter valves

- Clean lters

- Connect hoses correctly

- Check power supplier and

socket

- Replace power supply

- Check connection and if

problem persists, contact

customer service

- Check control knob

- Contact customer service

Water running constantly? - Electronic device faulty - Turn the tap off and on. If

problem persists, contact

customer service

Water ow too low? - Supply pressure too low

- Filter valves not open

enough

- Filter valves clogged

- Check supply line

- Open lter valves further

- Clean lters

Water temperature cannot be

adjusted?

- Water supply failure or tem-

perature difference between

hot and cold water supply

line too low

- Dirty lter taps

- Control unit fault

- Check water supply

- Clean lters

- Contact customer service

Dripping tap? - Electronic device faulty - Turn the tap OFF and ON

again. If problem persists,

contact customer service

Minimum ow rate too high?

Either completely hot or

completely cold water cannot

be obtained?

- Control unit reset error - Turn control unit off, wait 5

seconds and turn back on. If

the problem persists, contact

customer service

NOTE:

The device must be turned off by disconnecting the power supply unit and removing the batteries.

ENGLISH

26

Disposal

Dispose of any batteries, disused accessories and packaging in order that they can be

recycled in an environmentally-friendly way.

Only for EC countries: Do not dispose of any used batteries with household waste!

In accordance with the provisions of Directive 2002/96/EC on waste electrical and electronic

equipment (WEEE) and its transposition into national law, spent batteries should be collected

separately and reused ecologically.

Limitations of use

The appliance is not designed to be used by persons (including children) with limited physical,

sensory or mental capabilities, or by anyone with a lack of experience or knowledge, unless the

same are supervised and instructed when using the appliance by a person responsible for their

safety. Children must be supervised to ensure that they do not play with the appliance.

Replacing the Batteries

- The batteries should only be replaced with new batteries of the same type as those listed in this

manual.

- Before replacing the batteries, turn off the control unit by disconnecting the power supply.

- Make sure that the polarity of the batteries and connectors match.

- Dispose of any replaced batteries according to current regulations.

ENGLISH

Page is loading ...

Whirlpool PM05016, FAF 012 IX, FAF 012 IXL, FAF 013 IX, FAF 014 IX, FAF 015 BL, FAF 015 IX, FAF 015 WH User guide

Related papers

Other documents