2. Minka Group
  3. P5610-66A

Minka Group P5610-66A User manual

  • I have reviewed the installation instructions for the P5610-66A light fixture. This document provides a comprehensive guide on how to safely install your new fixture, covering everything from shutting off power to completing the final installation steps. The instructions include details on wiring, mounting, and bulb installation. I am ready to answer any questions you might have about the product or its installation process.
  • What should I do before starting the installation?
    How do I attach the circular strap?
    What type of light bulb can I use?
Set# A-022-130D
-Circular Strap*1
-Ground Screw*1
-Mounting Screw*2
Glass#PG5610
INSTALLATION INSTRUCTIONS
Item# P5610-66A (New. 19/12/2022)
READ AND SAVE THESE INSTRUCTIONS
W A R N I N G ! S H U T P O W E R O F F AT F U S E O R C I R C U I T B R E A K E R .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
Fig. 1
Fig. 2
PREPARATION (Fig. 1)
1. Shut off
power at the fuse box or circuit breaker box and
remove the old fixture including the mounting hardware.
2. Carefully unpack your new fixture and lay out all the
parts in a clean area. Take care not to misplace any
small parts necessary for installation.
3. Loosen screw（D）to remove circular strap (B).
4. Attach circular strap (B) to Junction box (Not included)
using mounting screws (A) (Size: #8-32N*L1
”). The side
of the circular strap (B) marked “GND” must face out.
CONNECTING THE WIRES (Fig. 2)
5. Connect the electrical wires as shown in (Fig.2). Making
sure that all wire connectors are secured. If your
junction box
has a ground wire (green or bare copper),
connect fixture’s ground wire to it. Otherwise, connect
fixture’s ground wire directly to circular strap (B) using
green screw provided.
6. Tuck wire connectors neatly into the junction box.
COMPLETING THE INSTALLATION (Fig. 1)
7. Place fixture body (E) onto circular strap (B) and secure
with screws (D).
8. Place glass (F) over socket and secure with socket ring
(G).
9. Install (1) medium base bulbs (H) up to 100 watts each
or CFL or LED equivalent (not included) in accordance
with the fixture specification —DO NOT EXCEED THE
MAXIMUM WATTAGE RATING! (NE PAS DEPASSER LA
PUISSANCE NOMINALE MAXIMALE!).
Your installation is now complete.
Return power to the
junction box and test the fixture.
Note:
Illustration (Fig. 1) on this manual is for
installation purposes only. It may or may not be
identical to the fixture purchased.
FIXTURE
WIRES
Black or
Smooth
HOUSE
WIRES
Black
(Hot)
FIXTURE
WIRES
White or
Ribbed
HOUSE
WIRES
White
(Neutral)
FIXTURE
WIRES
Bare
Copper
(Ground)
HOUSE
WIRES
Green
(Ground)
/