2. FLEXCO
  3. R2T Tool Anvil Inserts

FLEXCO R2T Tool Anvil Inserts Operating instructions

  • I have reviewed the installation instructions for the R2T Anvil Insert. This document outlines the correct method for installing the anvil insert, emphasizing the use of a nail/rivet assembly and advising against direct hammer blows to prevent distortion. I'm ready to answer your questions regarding the installation process.
  • How should I insert the anvil?
    What should I use to drive the insert in?
    Can I hit the insert directly with a hammer?
R2T Tool Anvil Inserts
Installation Instructions
1. Insert anvil into proper
location.
2. Use nail/rivet assembly to
drive the insert in.
NOTE: Do not pre-insert anvils and then finish
hitting them with a hammer. Hitting directly
on the insert can distort it enough to render it
useless. You may use a piece of flat steel or the
equivalent to serve as a buffer between hammer
blows and the insert.
R2/305
X0653
/