2. JasonL
  3. STBPR214ME

JasonL STBPR214ME Operating instructions

  • Hello! I've reviewed the Installation Guide for the jason.l Table Switch System 2 Person Run. This guide provides instructions on how to assemble the table, including steps on connecting leg brackets, beams, and table tops. I'm here to assist with any questions you might have about the setup or its components.
  • What tool is required for assembly?
    What size are the table tops?
    What should I do before attaching the table tops?
    What should I do if bolts are not dropping into joints?
Note: Please ignore any pre-drilled holes or nut inserts that maybe present in your top(s). They will not match your particular
table/desk base and woods screws will be required to be screwed directly into the underside of the top.
Note: It is important to fully tighten all bolts and screws before attaching the top(s) so that the frame is suciently rigid.
Failure to do this may aect stability once the tops are attached.
Tools Required: Power screwdriver.
INSTALLATION GUIDE
Switch System
2 Person Run
Size: 1400x800 mm
Page 1 of 5
Need help!
Call us on
1300 527 665
www.jasonl.com.au
Page 2 of 5
INSTALLATION GUIDE
Switch System
2 Person Run
Size: 1400x800 mm
Need help!
Call us on
1300 527 665
www.jasonl.com.au
Table Top x2 (1400x800mm)
Leg x6
Leg Bracket x6
Beam Bracket x14
Switch Beam x4 (950mm)
Switch Beam x3 (325mm)
L-Bracket x8
1
2
3
4
5
6
7
Hex Nut x6
L-Bracket screws x6
Hex Head screws x6
M8x40mm Bolt x12
M8x20mm Bolt x14
8
9
10
11
12
COMPONENTS
SCREWS
8
4
1
2
3
4
5
10 11
6
9
7
12
Page 3 of 5
INSTALLATION GUIDE
Switch System
2 Person Run
Size: 1400x800 mm
Need help!
Call us on
1300 527 665
www.jasonl.com.au
Join Leg Brackets to each Leg using screws to secure them, as follow.
Securely connect each Beam to each Beam Bracket. Screw to secure. Insert Hex Nut on each Beam Bracket.
01
03 04
Join 1 L-Bracket through each 950mm Beam
and 1 L-Bracket through each 325mm Beam.
02
Page 4 of 5
INSTALLATION GUIDE
Switch System
2 Person Run
Size: 1400x800 mm
Need help!
Call us on
1300 527 665
www.jasonl.com.au
For the 2 central legs, attach as presented, using T Beam Bracket.
06
Position as presented, and proceed to screw to ensure each corner of the frame.
05
If this bolt does not drop into the joint
use the Allen key to screw it all the way
in so that it creates its own thread.
This will ensure a nice, tight joint.
Page 5 of 5
INSTALLATION GUIDE
Switch System
2 Person Run
Size: 1400x800 mm
Need help!
Call us on
1300 527 665
www.jasonl.com.au
Directly screw into table tops, using L-Bracket
screws through each L-Bracket.
07
Note: It is important to fully tighten all bolts and
screws before attaching the top(s) so that the frame is
suciently rigid. Failure to do this may aect stability
once the tops are attached.
/