14
%
*
[SR14690(ALL)05/95]
Safety Belt Extension Assembly
[SR14692(ALL)05/95]
A safety belt that is too short even when fully
extended can be lengthened. You can add about
eight inches (20 cm) to the belt length with a
safety belt extension assembly. Safety belt
extensions are available at no cost from your
dealer.
*
[SR14693(ALL)05/95]
Use only extensions manufactured by the same
supplier as the safety belt. Manufacturer
identification is located at the end of the
webbing on the label. Also, use the safety belt
extension only if the safety belt is too short for
you when fully extended. Do not use extension
to change the fit of the shoulder belt across the
torso.
*
[SR14694(ALL)05/95]
RWARNING
Failure to follow these instructions will
affect the performance of the safety belts
and increase the risk of personal injury.
%
*
[SR14696(ALL)05/95] Safety Belt Maintenance
*
[SR14698(ALL)05/95]
Check the safety belt systems periodically to make
sure that they work properly and are not damaged.
%
*
[SR14700(ALL)05/95]
All safety belt assemblies, including retractors,
buckles, front seat belt buckle support assemblies
(slide bar) (if equipped), child safety seat tether
bracket assemblies (if equipped), and attaching
hardware, should be inspected after any
collision. Ford recommends that all safety belt
assemblies used in vehicles involved in a
collision be replaced. However, if the collision
was minor and a qualified technician finds that
the belts do not show damage and continue to
operate properly, they do not need to be
replaced. Safety belt assemblies not in use
during a collision should also be inspected and
replaced if either damage or improper operation
is noted.
File:prsrp.ex
Update:Fri Jun 23 19:39:12 1995