MK-APC/H Air Powered Chop Saw

The MK-APC/H Handheld Air Powered Chop Saw is portable with a non-slop belt designed to improve power

transfer. The MK-APC/H has the benefits of an air motor with no performance loss when compared to conven-

tionally powered competitors. This saw can be used in the same way as a conventional gas high speed saw, but

without having to worry about rocking of saw during cutting. This saw is ideal for concrete pile cutting, demolition

and pipe cutting at below grade. An easy to read oiler is included for quick check of fluid levels by the operator.

Air Requirement 85 cfm of air at 80 psi

Blade Capacity 14"

Depth of Cut 5"

www.mkdiamond.com |

[email protected]

© 2020 MK Diamond Products, Inc. All Rights Reserved. Images and specifications are subject to change without notice. MK-APC/H Sell Sheet Part # AP080259 (06/20)

MK-APC/W Air Powered Walk Behind Concrete Saw

The MK-APC/W Air Powered Walk Behind Concrete Saw has a 9.5 hp pneumatic motor with gear box drive. The

L x W x H (inches)

L x W x H (mm)

42" x 19" x 41"

1,067 x 483 x 1,041

Weight 106 lbs. (48kg) 108 lbs (49kg)

Part# 168286 167990

WARNING: Cancer and Reproductive Harm - www.p65warnings.ca.gov

!