2. Conductix Wampfler
  3. CXWA
CXWA

Conductix Wampfler CXWA User manual

  • Hello! I've reviewed the Supplemental User's Manual for the CXWA and Blue modules. It primarily details the integration instructions, FCC compliance, and testing requirements. The modules are certified under FCC Part 15.249, and the host device must be tested for spurious emissions. I am ready to answer any questions you might have regarding the document or the module itself.
  • Under which FCC part is the module certified?
    Why does the host device need to be tested for spurious emissions?
    Does the module require additional testing for Part 15C?
    Can I use external antennas with this module?
Supplemental User’s Manual
INTEGRATION INSTRUCTIONS per FCC KDB 996369 D03, Section 2.0
2.2 List of applicable FCC rules
The module has been certified for use under FCC Part 15.249 only
2.3 Summarize the specific operational use conditions
The host device must be tested for spurious emissions due to the module’s lack of its own shielding.
2.4 Limited module procedures
The host device must be tested for spurious emissions due to the module’s lack of its own shielding.
2.5 Trace antenna designs
Antenna is integrated into module and the module should be used with no other antennas
2.6 RF exposure considerations
Device is inherently compliant with RF exposure requirements since it meets 15.249 requirements
2.7 Antennas
Antenna is integrated into module and the module should be used with no other antennas
2.8 Label and compliance information
Module contains its own label
2.9 Information on test modes and additional testing requirements
None required.
2.10 Additional testing, Part 15 Subpart B disclaimer
This module has been tested and certified to comply with FCC Part 15C requirements. The host
device to which it is installed may require additional testing to show compliance with FCC Part 15B
requirements.
Supplemental User’s Manual
INTEGRATION INSTRUCTIONS per FCC KDB 996369 D03, Section 2.0
Notice:
OEM should include the following warnings on the label:
“Contains FCC ID: 2ASM6-CXWA, IC:11769A-CXWA”
As well as the model name:
“VersaReel Blue”
Installer should include the following in the user’s manual:
“This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.”
“Changes of modification not expressly approved by the party responsible for compliance could void the
user’s authority to operate the equipment.”
/