SE X1 USB Installation guide

I have reviewed the user manual for the sE Electronics X1 USB microphone. The document provides setup instructions for both Mac and Windows systems, including driver installation and audio software configuration. I am ready to answer any questions regarding the microphone or its installation process.
How do I check if the X1 USB is working on a Mac?

Where can I download the Windows driver for the X1 USB?

What should I select as input and output devices in my Windows audio recording software?

X1 USB Driver Installation Instructions

For Mac:

• sE X1 USB is plug-and-play - therefore, simply plug the microphone into a USB 2.0 or 3.0

port on your Mac.

• To check that the X1 USB is working, check for the device under System Preferences >

Sound > Input & Output tabs.

• Under the Input tab with the X1 USB selected, you will see a signal level in the meter when

you talk into the microphone.

• You can set the sample rate up to 192kHz, depending on the audio software you are using.

For Windows:

• Please visit http://www.seelectronics.com/se-x1-usb-mic and download the sE X1 USB

Driver for Windows.

• Run the driver download: se-x1-usb-driver-windows and follow the instructions to install the

driver, plugging in the sE X1 USB when prompted.

• Continue to follow the instructions to install the driver.

• We recommend restarting your computer once the installation is complete.

• Within your audio recording software, go to your audio preferences and select ASIO XMOS

USB Audio 2.0 as your input and output devices.

• You can set the sample rate up to 192kHz, depending on the audio software you are using.

For further assistance, please contact [email protected].