Princess 221203 User manual

Category
Blenders
Type
User manual
221203 Princess Stick Mixer
Nederlands 4
English 9
Français 14
Deutsch 19
Español 25
Italiano 30
Svenska 35
Norsk 40
Português 45
Polski 50
9
EN
Safety instructions
General safety
Read the manual carefully •
before use. Keep the manual
for future reference.
Only use the appliance and •
the accessories for their
intended purposes. Do not
use the appliance and the
accessories for other purposes
than described in the manual.
Do not use the appliance if •
any part or any accessory is
damaged or defective.
If a part or an accessory is
damaged or defective,
it must be replaced by the
manufacturer or an authorised
repair agent.
The appliance is not intended •
for use by persons (including
children) with reduced
physical, sensory or mental
capabilities, or lack of
experience and knowledge,
unless they have been given
supervision or instruction
concerning use of the
appliance by a person
responsible for their safety.
Children should be supervised •
to ensure that they do not
play with the appliance.
Do not use the appliance near •
bathtubs, showers, basins or
other vessels containing water.
Do not immerse the •
appliance in water or other
liquids. If the appliance is
immersed in water or other
liquids, do not remove the
appliance with your hands.
Immediately remove the mains
plug from the wall socket.
If the appliance is immersed
in water or other liquids, do
not use the appliance again.
Clean the appliance and the •
accessories. Refer to the section
"Cleaning and maintenance".
Electrical safety
Before use, always check that •
the mains voltage is the same
as the voltage on the rating
plate of the appliance.
The appliance is not intended •
to be operated by means of
an external timer or separate
remote-control system.
Connect the appliance to an •
earthed wall socket. If
necessary, use an earthed
extension cable of a suitable
diameter (at least 3 x 1 mm
2
).
For additional protection, •
install a residual current
10
EN
device (RCD) with a rated
residual operating current
that does not exceed 30 mA.
Make sure that water cannot •
enter the contact plugs of
the mains cable and the
extension cable.
Always fully unwind the mains •
cable and the extension cable.
Make sure that the mains •
cable does not hang over the
edge of a worktop and cannot
be caught accidentally or
tripped over.
Keep the mains cable away •
from heat, oil and sharp
edges.
Do not use the appliance if •
the mains cable or the mains
plug is damaged or defective.
If the mains cable or the
mains plug is damaged or
defective, it must be replaced
by the manufacturer or an
authorised repair agent.
Do not pull the mains cable •
to disconnect the mains plug
from the mains.
Disconnect the mains plug from •
the mains when the appliance
is not in use, before assembly
or disassembly and before
cleaning and maintenance.
Safety instructions for stick
blenders
The appliance is suitable for •
domestic use only.
Do not use the appliance •
outdoors.
Do not use the appliance in •
humid surroundings.
Keep the appliance away •
from heat sources. Do not
place the appliance on hot
surfaces or near open flames.
Make sure that your hands •
are dry before touching the
appliance.
Do not touch moving parts. •
Keep your hands away from
the moving parts during use
and during cleaning and
maintenance.
Beware of sharp parts. Keep •
your hands away from the
sharp parts. The appliance
uses sharp blades in the
blending attachment and the
chopping attachment.
Beware of hot parts. Wait •
until the appliance has cooled
down before touching the
housing and the parts of the
appliance. The appliance
becomes hot during use.
Be extra careful during •
cleaning and maintenance.
11
EN
Be extra careful when
emptying the blending mug
or the chopping container.
Be extra careful when
handling the sharp blade.
Do not leave the appliance •
unattended during use.
Cleaning and maintenance
(fig. A & B)
The appliance must be cleaned after each use.
Warning!
- Before cleaning or maintenance, switch off
the appliance, remove the mains plug from
the wall socket and wait until the appliance
has cooled down.
- Do not immerse the appliance in water or
other liquids.
Caution!
- Do not use aggressive or abrasive cleaning
agents to clean the appliance.
- Do not use sharp objects to clean the
appliance.
- Do not clean the motor unit, the blending
attachment, the chopping attachment and
the whisking attachment in the dishwasher.
Regularly check the appliance for possible •
damage.
Clean the motor unit (4) with a soft, damp •
cloth. Thoroughly dry the motor unit (4)
with a clean, dry cloth.
Clean the accessories:•
- Blending applications: Clean the blending
attachment (6) under running water
(fig. B1). Clean the blending mug (7) and
the lid (8) in soapy water or in the
dishwasher. Rinse the blending mug (7)
and the lid (8) under running water.
- Chopping applications: Clean the chopping
attachment (9) under running water
(fig. B2). Clean the chopping blade (10),
the chopping container (11) and the lid
(12) in soapy water or in the dishwasher.
Rinse the chopping blade (10), the
chopping container (11) and the lid (12)
under running water.
- Whisking applications: Clean the
whisking attachment (13) under running
water (fig. B3). Clean the whisk (14) in
soapy water or in the dishwasher. Rinse
the whisk (14) under running water.
- Thoroughly dry the accessories with a
clean, dry cloth.
Description (fig. A)
Your 221203 Princess stick blender has been
designed for blending, chopping and whisking
applications. The appliance is suitable for
indoor use only. The appliance is suitable for
domestic use only.
1. Inching switch
2. On/off button (low speed)
3. On/off button (high speed)
4. Motor unit
5. Accessory holder
Blending applications
6. Blending attachment
7. Blending mug
8. Lid (blending mug)
Chopping applications
9. Chopping attachment
10. Chopping blade
11. Chopping container
12. Lid (chopping container)
Whisking applications
13. Whisking attachment
14. Whisk
Use (fig. A)
Warning!
- Before assembly or disassembly, switch off
the appliance, remove the mains plug from
the wall socket and wait until the appliance
has cooled down.
Blending applications
The blending attachment (6) can be used for
the following applications: preparing
smoothies, shakes and juices; preparing cold
soups; preparing dressings, dips and sauces.
12
EN
Warning!
- Do not leave the appliance switched on
continuously for more than one minute.
- Do not switch on the appliance when the
blending mug (7) is empty.
- Make sure that the motor unit (4) and the
blending attachment (6) do not come into
contact with water or other liquids.
- The blending mug (7) and the lid (8) are
not suitable for use in the microwave.
Mount the blending attachment (6) to the •
motor unit (4) by turning it
counterclockwise until it clicks into place.
Put the ingredients into the blending mug •
(7).
Insert the mains plug into the wall socket.•
Place the blending mug (7) onto the lid (8) •
on a stable and flat surface.
Place the blending attachment (6) into the •
blending mug (7). Make sure that the
accessory is located in the ingredients.
Use the inching switch (1) to test whether the •
appliance blends the ingredients properly.
To switch on the appliance, keep the on/off •
button (2/3) pressed.
Move through the ingredients with a gentle •
up-and-down movement. The appliance
blends the ingredients in a few seconds.
The longer the appliance is switched on,
the finer the ingredients will be blended.
To switch off the appliance, release the •
on/off button (2/3).
Remove the mains plug from the wall socket.•
Allow the appliance to cool down •
completely.
Remove the blending attachment (6) from •
the blending mug (7).
Remove the blending attachment (6) from •
the motor unit (4) by turning it clockwise.
Place the lid (8) onto the blending mug (7) •
until you use the ingredients for further
food processing.
Chopping applications
The chopping attachment (9) can be used for
chopping meat (raw and cooked), vegetables,
fruits (fresh and dried), nuts, herbs, spices, etc.
Warning!
- Do not leave the appliance switched on
continuously for more than 10 seconds.
- Do not switch on the appliance when the
chopping container (11) is empty.
- Make sure that the motor unit (4) and the
chopping attachment (9) do not come into
contact with water or other liquids.
- The chopping container (11) and the lid (12)
are not suitable for use in the microwave.
Mount the chopping attachment (9) to the •
motor unit (4) by turning it
counterclockwise until it clicks into place.
Place the chopping container (11) onto the •
lid (12) on a stable and flat surface.
Place the chopping blade (10) into the •
chopping container (11).
Cut the food into pieces. Make sure that the •
pieces of food fit in the chopping container
(11).
Put the ingredients into the chopping •
container (11).
Insert the mains plug into the wall socket.•
Place the chopping attachment (9) onto •
the chopping container (11).
Use the inching switch (1) to test whether •
the appliance chops the ingredients
properly.
To switch on the appliance, keep the on/off •
button (2/3) pressed.
Firmly hold the appliance during the process. •
The appliance chops the ingredients in a
few seconds. The longer the appliance is
switched on, the finer the ingredients will
be chopped.
To switch off the appliance, release the •
on/off button (2/3).
Remove the mains plug from the wall socket.•
Allow the appliance to cool down •
completely.
Remove the chopping attachment (9) from •
the chopping container (11).
Remove the chopping blade (10) from the •
chopping container (11).
Remove the chopping attachment (9) from •
the motor unit (4) by turning it clockwise.
Place the lid (12) onto the chopping •
container (11) until you use the ingredients
for further food processing.
13
EN
Whisking applications
The whisking attachment (13) can be used for
beating eggs, whipping cream and frothing milk.
Warning!
- Do not leave the appliance switched on
continuously for more than two minutes.
- Do not switch on the appliance when the
mixing bowl is empty.
- Make sure that the motor unit (4) and the
whisking attachment (13) do not come
into contact with water or other liquids.
Insert the whisk (14) into the whisking •
attachment (13).
Mount the whisking attachment (13) to •
the motor unit (4) by turning it
counterclockwise until it clicks into place.
Place a mixing bowl on a stable and flat •
surface.
Put the ingredients into the mixing bowl.•
Insert the mains plug into the wall socket.•
Place the whisk (14) into the mixing bowl. •
Make sure that the accessory is located in
the ingredients.
Use the inching switch (1) to test whether the •
appliance whisks the ingredients properly.
To switch on the appliance, keep the on/off •
button (2/3) pressed.
Move the appliance clockwise during the •
process.
To switch off the appliance, release the on/•
off button (2/3).
Remove the mains plug from the wall socket.•
Allow the appliance to cool down •
completely.
Remove the whisk (14) from the mixing bowl.•
Remove the whisking attachment (13) from •
the motor unit (4) by turning it clockwise.
Remove the whisk (14) from the whisking •
attachment (13).
© Princess 2013 08/13
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11
  • Page 12 12
  • Page 13 13
  • Page 14 14
  • Page 15 15
  • Page 16 16
  • Page 17 17
  • Page 18 18
  • Page 19 19
  • Page 20 20
  • Page 21 21
  • Page 22 22
  • Page 23 23
  • Page 24 24
  • Page 25 25
  • Page 26 26
  • Page 27 27
  • Page 28 28
  • Page 29 29
  • Page 30 30
  • Page 31 31
  • Page 32 32
  • Page 33 33
  • Page 34 34
  • Page 35 35
  • Page 36 36
  • Page 37 37
  • Page 38 38
  • Page 39 39
  • Page 40 40
  • Page 41 41
  • Page 42 42
  • Page 43 43
  • Page 44 44
  • Page 45 45
  • Page 46 46
  • Page 47 47
  • Page 48 48
  • Page 49 49
  • Page 50 50
  • Page 51 51
  • Page 52 52
  • Page 53 53
  • Page 54 54
  • Page 55 55
  • Page 56 56

Princess 221203 User manual

Category
Blenders
Type
User manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI