F.J. Moore 2 Installation guide

500 Washington Street West - Cannon Falls, MN 55009

Phone (800) 658-2331 - FAX (507) 263-4439

www.fjmooremfg.com

Worlds Best Flashing – Cover-All Products

PROPER INSTALLATION OF ROOF CAPS:

BY F.J. MOORE MFG. CO.

1. CUT THE VENT PIPE 2" - 5" ABOVE TOP OF THE BASE SLEEVE, TO ALLOW FOR ROOF

MOVEMENT (EXPANSION & CONTRACTION).

2. LAY THE BASE FLASHING ON ROOF BESIDE THE VENT PIPE. TO ADJUST TO THE EXACT

PITCH, USE THE HIP CORNER TABS TO INCREASE OR DECREASE THE PITCH.

To INCREASE the Pitch - Push the Hips IN To DECREASE the Pitch - Pull the Hips OUT

3. PLACE THE BASE FLASHING OVER THE PIPE. ROTATE UNDER 1 ROW OF SHINGLES.

4. CENTER THE PIPE SO THERE IS ABOUT THE SAME AMOUNT OF AIR SPACE AROUND

PERIMETER, BETWEEN THE PIPE AND THE BASE SLEEVE.

5. INSTALL THE TOP SLEEVE. TIGHTEN THE RING CLAMP (NUT/BOLT).

6. NAIL THE BASE FLASHING TO THE ROOF.

IT’S AS EASY AS 1-2-3-4-5-6

Pipe should be cut off 2” - 5" above the top of the base sleeve

Plumbing / Electrical / Roofing Vent Flanges / Metal Specialists

www.fjmooremfg.com

F.J. MOORE

MFG. CO.

This manual is also suitable for

Download PDF