Gorilla Playsets Jumbo Binoculars Installation guide

Gorilla Playsets
Brand
Gorilla Playsets
Model
Jumbo Binoculars
Type
Installation guide

This manual is also suitable for

Pivot Rod
when assembled)
5/16" x 1-1/4"
Binoculars
8mm
Acorn Nut
8mm
Washer
8mm Washer
Binocular Base
8mm x 106mm
(11-1/2" L x 6-1/2"H x 10-1/2" W
Lag Screw
4 X 4 BOARD
SHOWN
(NOT INCLUDED)
AND NOT ROTATE.
2-3/4" MINIMUM
FOR BASE TO FIT PROPERLY
1-1/4" MINIMUM
TO AVOID SCREW
GOING THROUGH
BOARD.
Binoculars.
Line up the holes in the Binocular Base with the hole on the bottom side of the
Jumbo Binoculars (07-0003)
3: Slide the 8mm diameter x 106mm length Pivot Rod through the holes.
4: Fasten one 8mm Acorn Nut and one 8mm Washer on each end of the Pivot Rod.
1: Attach the Binocular Base to the top of the wood railing on your play set.
Fasten with one 5/16" x 1-1/4" lag screw and one 8mm washers included with the
Binoculars.
2: Place the bottom side of the Binoculars with the hole in it inside the Binocular Base.
!WARNING! **DO NOT LOOK INTO SUN OR OTHER BRIGHT LIGHTS WITH BINOCULARS**
Please note: Binoculars do not magnify objects. Binoculars are intended for make-believe-play by children.
*FOR RESIDENTIAL USE ONLY*
*FOR CHILDREN AGES 3-11*
  • Page 1 1

Gorilla Playsets Jumbo Binoculars Installation guide

Gorilla Playsets
Brand
Gorilla Playsets
Model
Jumbo Binoculars
Type
Installation guide
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents