83-311 1219
Y E S
N O
N O
MOUNTING INSTRUCTIONS
Gunne l
o r
Tr a nso m
Gunne l
o r
Tr a nso m
Gunne l
o r
Tr a nso m
CONTENTS
• Polyethylene Bait & Filet Table with
Stainless Steel Hinged Mount
• Polyethylene Mounting Pad
• Stainless Steel Push/Pull Pin
• (2) Stainless Steel Mounting Screws
(#10 x 1" oval head self-tapping)
B
D
D
C
E
F
A
Hinged
Mount
Table
Mounting
Pad
1. If needed, attach hinged mount to table.
Slide hinged mount into mounting pad,
lining up “A” and “B”. Insert pin “C”.
2. Select desired table position on the
boat. Ensure table has slight angle for
overboard water drainage
(see illustration at left).
3. Mark gunnel or transom where “C”
touches and drill a 17/64" hole.
4. Re-position table assembly so that pin
“C” is in hole just drilled.
5. Double-check position of table and
mounting pad. Mounting pad should
be parallel with gunnel or transom.
• Mark screw holes “D”.
• Using an 11/64" drill bit,
drill pilot holes.
• Insert lanyard in slot in back
of mounting pad “F”.
• Install screws “E”.
Use caution when removing pin.
Hold on to table. Table may fall overboard.
Back of
Mounting
Pad
F
-
1
Magma T10-311B Operating instructions
- Type
- Operating instructions
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Other documents
-
Boston Whaler 320 Outrage Owner's manual
-
-
-
-
-
-
-
-
-