QDL-1000
1.2 7/24/2009
For a more in-depth look at the duplication
process and menu structure, please refer to
the appropriate sections of the User’s
Manual.
QDL-1000 Initial Setup
1. Unpack the QDL-1000 Disc Duplicator and place it in the
selected workspace. This space should be level and have
enough space to allow for the extension of the Input/Output
bin assembly.
2. Plug in the AC power cord to the back of the QDL-1000 Disc
Duplicator.
3. Pull out the Disc Tray using the front handle until the tray
locks into place.
4. Turn on the QDL-1000 Disc Duplicator using the switch on
the back.
QDL-1000 Disc Duplicator
Using the QDL-1000 Disc Duplicator Autocopy function
1. Load yor blank media into the input bin.
2. Load your Master Disc on top of the blank media.
3. Flip the disc slide up towards the recorder
drive. This slide is used to direct the burned
discs into the output bin.
4. Use the Up or Down buttons to navigate
through the menu until the display reads
15. Autocopy.
5. Press the OK button to begin duplication of your Master Disc.
6. When the blank discs have all been burned, remove the discs
from the output bin. Don’t forget that your Master Disc will be
the bottom disc in the stack.
For more advanced duplication options and information
on the menu functions, please refer to the User’s Manual.
MICROBOARDS
1.Copy (MM)
T
o contact T
echnical Support, visit www
.microboards.com, call 952-556-1639, or e-mail
[email protected]Attention
For best results, use CD or DVD discs that have a matte or smooth
printable surface. A sample pack of appropriate discs has been
provided with this unit.
Shiny silver or laquered discs may not unload to the
output bin correctly due to their sticky surface, and are
not recommended for use with this product.