Öhlins Front Fork Kit for Kawasaki KX 250 F
FGKA 1193
Application Specific Mounting Instructions
Issued 2010-09-13
Kit Contents (application specific)
Recommended Tools (application specific)
Hydraulic Stop Cup
Set-Up Data
Spring Recommendation
Part No. Pcs.
Front Fork kit FGKA 1193 1
Base plug (with o-rings) 15430-06 2
Spacer 2 mm 15443-02 14
Hydraulic Stop Cup 15456-07 2
Seal Platform (with o-rings) 15452-02 1
OEM Fork Cap Tool 50 mm, octagon
Socket for OEM Base Plug 21 mm
Socket for Öhlins Base Plug 21 mm
FGKA 1193 Cartridge kit comes with a Öhlins hydraulic stop,
and a fork bottom seal platform. Stop cup shall be installed
according to step 10 in the Owners manual and General
mounting instruction. Seal platform with o-rings shall be
installed between the 47mm inner tube and fork bottom on the
left fork leg. This requires removal of the fork bottom from the
inner tube. OEM seal/platform/ hydraulic stop cup (one piece)
shall be removed.
Rebound Damping 15 clicks
Compression Damping 15 clicks
Spring Preload 0 mm
Fluid Volume (each leg) 0,340 litre
Cartridge Kit FGKA 1193 shall be used together with
Öhlins Front Fork Springs part no. 08762-xx. For rate
recommendations, see Owner’s Manual/ General Mounting
Instructions.
Note!
The fork springs need to be ordered separately depending on the
rider’s choice of spring rate.
Part No. Pcs.
Circlip 15440-01 2
Öhlins Sticker 00192-01 2
TTX Cartridge Sticker 00191-29 2
O-ring 00338-02 1
O-ring 00338-36 1
Owners Manual 07296-90 1
Spring preload range -2 to 8 mm
(can be adjusted by adding/removing washers 15443-02)
Fluid volume range (each leg) 0,300 - 0,400 litre
Öhlins Front Fork uid 01312-01
/