01. Controller Description 02. LED Modes
03. Addressable RGB/RGB Mode 04. Addressable RGB/RGB Mode
5. Addressable RGB/RGB Mode
06. Color Adjustment Mode
Front Back Left Right
Top Bottom
Press:
1. Spectrum Cycle
2. Uni-LED Monotone
Step Cycle
3. Dual-LED Monotone
Step Cycle
4. Breathe Cycle
5. Monotone LED
Build-up Cycle
6. Chromatic LED
Step Cycle
7. Turn Off
8. Testing Mode
Default:
When plugged in right side
4 LED will light up. For the
purpose of demonstration
they will be shaded to
indicate that it is on
Press Once:
To Switch to standard RGB
Mode
Press Again:
To switch back to
Addressable RGB mode
Press:
To switch colors in LED
mode
NOTE:
In LED mode 1 and 6 this
is not applicable as it is a
multi-color function.
IMPORTANT: the 7 LEDs indicated in the next 3
steps are built internal, indicated in the
illustration for explanation purposes. Will not be
visible when off
Note:
After switching to RGB
Mode, right side 1 LED Will
light up
Note:
Bottom 2 LED always on
when plugged in
USER MANUAL
07. Lighting Speed Adjustment 08. Left Side Functions
09. Reset Function (Plugged in) 10. Right Side Function
11. Top Function 12. Bottom Functions
Press
1. Slowest
2. Slow
3. Medium
4. Fast
5. Fastest
Expansion Slot(NA)
Mirage Effect
(Software Required)
Case IO Panel Reset
Port
Motherboard Reset
Port (Connect using
cable included)
When Plugged in:
The Reset Button on the Case IO
Panel can be used to switch between
LED modes, (same as in Step 2).
Press and Hold for 5 secs to restart
your computer
Addressable RGB
Channel 4
Addressable RGB
Channel 3
Addressable RGB
Channel 2
Addressable RGB
Channel 1
SATA Power Port
RGB Motherboard
Port
Addressable RGB
Motherboard Port
USB Software
Port
USER MANUAL
/