Lay the cable along the center of the suppressor
with the connector to your left.
Carefully, snap the two halves together with the
looped cable routed through the center.
Loop the right end of the cable under the suppres-
sor and back up again laying the cable along the
center of the suppressor.
This completes the installation of the suppressor.
©2008 Control Company. 92-8141-00 Rev. 1 120508
Static
diScharge
radio
Frequency
Protection
For your
thermometer
Static generated, radio frequency can affect
any cable through the air or by physical con-
tact. To protect against radio frequency, install
a suppressor onto your thermometers cable to
absorb radio frequency as follows:
controL comPany
4455 Rex Road
Friendswood, Texas 77546 USA
Ph. 281 482-1714 • Fax 281 482-9448
E-mail [email protected] • www.control3.com
Control Company is ISO 9001 Quality-Certied by
DNV and ISO 17025 accredited as a Calibration
Laboratory by A2LA.
-
1
-
2
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
Optimus LS-320 User manual
-
Symmetricom TimeSource 500 User manual
-
Roland GS-6 Owner's manual
-
Motorola ABZ89FT7636 User manual
-
Nokia Solutions and Networks SC 300 User manual
-
Campbell Scientific COM310 Owner's manual
-
AES 7170 Specification
-
Danby DDL Owner's manual
-
Nortel WLAN Security Switch 2361 Installation guide
-
Tripp Lite TLP66RCG Owner's manual
