Stinger SEADP1RGB Owner's manual

Brand: Stinger

Model: SEADP1RGB

Type: Owner's manual

SEADP1RGB

1.5” MARINE-GRADE RGB

LED DRAIN PLUG REPLACEMENT

IMPORTANT NOTES!

 Lights are for underwater use only.

 Do not operate above water for over 5 minutes.

 12V / DC operation only.

 Supplied fuse must be used on Positive lead.

1. Remove existing drain plug.

2. Feed the SEADP1 power wire through the drain open-

ing and screw in the light assembly. Hand tighten rmly.

3. On the inside of the boat, leave enough slack in the

power cable so the drain plug can be removed. Secure

and route power cable to RGB control module.

4. Connect wiring directly to a 12V source or use a

switch. Supplied fuse must be used on positive lead.

5. When mounting the RGB control module, the IR Receiver

must be visible for the remote control to function.

  

87a

SWITCH

12V+

Positive +

Negative -

SEADP1RGB SPECIFICATIONS

Housing Material

Titanic Aluminum Alloy

Light Source RGB LED x 9

LED Power 27W

Beam Angle 180

Working Temperature

-4° - 104° (F)

-20° - 40 (C)

IP Rating IP68

Certication

CE, RoHS

ATC(ATE20081436)

Dimensions

1.77 x 1.77 x 2.44in

45 x 45 x 62mm

Weight 8.8oz / 250g

LIMITED WARRANTY:

Stinger warrants this product to be free of defects in materials and

workmanship for a period of one (1) years from the original date of

purchase. This warranty is not transferable and applies only to the

original purchaser from an authorized Stinger dealer in the United

States of America only. Should service be necessary under this war-

ranty for any reason due to manufacturing defect or malfunction,

Stinger will (at its discretion), repair or replace

the defective product with new or remanufactured product at no

charge. Damage caused by the following is not covered under

warranty: accident, misuse, abuse, product modication or

neglect, failure to follow installation instructions, unauthorized

repair attempts, misrepresentations by the seller. This warranty

does not cover incidental or consequential damages and does

not cover the cost of removing or reinstalling the unit(s). Cosmetic

damage due to accident or normal wear and tear is not covered

under warranty.

INTERNATIONAL WARRANTIES:

Products purchased outside the United States of America are

covered only by that country’s Authorized Stinger reseller and not

by Stinger. Consumers needing service or warranty information for

these products must contact that country’s reseller for information.

Stinger is a Power Brand of AAMP Global

15500 Lightwave, Clearwater, Florida 33760

P: 888-228-5560

[email protected]

www.stingerelectronics.com

RECEIVER

INSTALLATION

Stinger SEADP1RGB Owner's manual

Stinger SEADP1RGB Owner's manual

Stinger SEADP1RGB Owner's manual

Related papers

Other documents