ESAB Twist Lock Adapter Kit For Genuine Heliarc Torches User manual

TWIST LOCK ADAPTER KIT FOR

GENUINE HELIARC TORCHES

Part No. 0558002692

For Adapting HW-17 and HW-9 TIG TORCHES

The Twist Lock Adapter for the GENUINE Heliarc

Torches provide a way for a standard HW-17 and a

HW-9 to be used on power supplies with twist lock dinse

connectors. The connector body allows for connec-

tion of a standard power cable (3/8-24RHM). The

adapter kit includes connector body, insulator, and bard

hose connection with o-ring.

INSTALLATION

GAS HOSE TO DINSE CONNECTOR:

1. Place the brass connector body into the insulator.

(Make sure to line up the hole from the connector

body with the hole in the insulator.

2. Place the barb hose connector into the hole where

the insulator and the brass connector body are lined

up. Using a flat screwdriver, tighten the barb hose

connector.

3. Take the 12 inch gas hose and a clamp (supplied

by customer) and place it over the barb connector.

Make sure that the clamp is tightened to ensure

no leakage of gas.

INSTRUCTIONS for

F-15-680

March, 2001

12-in. Gas Hose

Hose Clamp

(Supplied by Customer)

Barb Hose Connector

O-ring

Insulator

Connector Body

Be sure this information reaches the operator.

You can get extra copies through your supplier.