KNIFE STERILISER
INSTRUCTION MANUAL
MODEL: DM079-A
1
Safety Tips
A service agent/qualified technician should carry out installation and any repairs if required. Do not
remove any components or service panels on this product
Consult Local and National standards to comply with the following:
o Health and safety at work legislation
o BS EN Codes of practice
o Fire Precautions
o IEE wiring regulations
o Building regulations
DO NOT use jet/pressure washers to clean the appliance
DO NOT immerse the appliance in water
DO NOT use the appliance outside
DO NOT bypass the safety interlocks
Always switch off and disconnect the power supply to the unit before cleaning
This appliance must only be used in accordance with these instructions and by persons competent to
do so.
Keep all packaging away from children. Dispose of the packaging in accordance with the
regulations of local authorities
If the power cord is damaged, it must be replaced by a APURO agent or a recommended qualified
technician in order to avoid a hazard
This appliance is not intended for use by persons (including children) with reduced physical, sensory
or mental capabilities, or lack of experience or knowledge, unless they have been given supervision
or instruction concerning the use of the appliance by a person responsible for their safety
Children should be supervised to ensure that they do not play with the appliance
DO NOT look directly at the lamp
Product Description
DM079 – APURO Knife Steriliser
Pack Contents
APURO Knife Steriliser Instruction manual
APURO prides itself on quality and service, ensuring that at the time of packaging the contents are supplied
fully functional and free of damage. Should you find any damage as a result of transit, please contact your
APURO dealer immediately.
2
Telephone Helpline: 130 0225960
Installation
Ensure you have adequate support to support the appliance and proceed to drill and install the fixing
screws
Once the screws are installed, locate the appliance on the wall by aligning the locating holes on the
back plate with the screws.
WARNING: Ensure the substrate and fixings used to mount the Knife Steriliser are suitable to support
the weight of the loaded unit.
If necessary, seek professional help to ensure the shelf is safely mounted.
3
Operation
Open the door, and put the Knives in the basket (Knifes should be washed and dried before placing
inside the sterliser). Ensure that the knives are held in the rack with the blade facing upwards and
angled towards the back of the unit. The handle of the knife should be resting on the floor of the unit
behind the front lip. Please see image below –
Close the door.
Connect the appliance to a suitable mains socket and turn on the power supply.
There are 2 methods of operating the Knife Sterilser
o Turn the timer dial to the ‘On’ position - the lamp will continue to operate until the door is
opened or the timer is returned to the position (note – 120 minutes is the time required to
ensure sterilisation)
o To use the timer function rotate the dial to the 120 minute position. The unit will then operate
for 120 minutes (note – 120 minutes is the time required to ensure sterilisation)
A safety switch turns off the lamp when the door is opened
DO NOT look directly at the lamp
Cleaning & maintenance
Always turn off the appliance and disconnect from power supply before cleaning.
Warm soapy water is recommended for cleaning. Cleaning agents may cause damage or leave
harmful residues when used for a prolonged period on stainless steel.
A APURO dealer or qualified technician should carry out repairs if required.
4
Telephone Helpline: 130 0225960
Trouble Shooting
Fault
Probable Cause
Action
The unit is not working
The Unit is not switched on
Check the unit is plugged in correctly and
switched on
Bulb has blown
Replace bulb (Bulb must have a light wave
length of 253.7nm – please contact your
retailer)
Plug and lead are damaged
Call APURO agent or qualified technician
Fuse in the plug has blown
Replace the plug fuse
Power supply
Check Power Supply
Internal wiring fault
Call APURO agent or qualified technician
The door is not shut correctly
Shut the door
Technical Specification
Model
Voltage
Power
Dimensions
h x w x d mm
Weight
(kg)
DM079
230v 50Hz
20w
600mm x 510mm x 150 mm
7
Electrical Wiring
This appliance is supplied with plug and lead.
The plug is to be connected to a suitable mains socket.
This appliance is wired as follows:
• Live wire (coloured brown) to terminal marked L
• Neutral wire (coloured blue) to terminal marked N
• Earth wire (coloured green/yellow) to terminal marked E
This appliance must be earthed, using a dedicated earthing circuit.
If in doubt consult a qualified electrician.
Electrical isolation points must be kept clear of any obstructions. In the event of any emergency
disconnection being required they must be readily accessible.
5
Compliance
The WEEE logo on this product or its documentation indicates that the product must not
be disposed of as household waste. To help prevent possible harm to human health
and/or the environment, the product must be disposed of in an approved and
environmentally safe recycling process. For further information on how to dispose of this
product correctly, contact the product supplier, or the local authority responsible for
waste disposal in your area.
APURO parts have undergone strict product testing in order to comply with
regulatory standards and specifications set by international, independent, and
federal authorities.
APURO products have been approved to carry the following symbol:
All rights reserved. No part of these instructions may be produced or transmitted in any form or by any means, electronic,
mechanical, photocopying, recording or otherwise, without the prior written permission of APURO.
Every effort is made to ensure all details are correct at the time of going to press, however, APURO reserve the right to
change specifications without notice.
6
DECLARATION OF CONFORMITY
Equipment Type
Knife Steriliser
Model
DM079-A
Legislation
C-Tick
AS/NZ 3820 Essential Safety Requirements for Low Voltage
Electrical Equipment
Standards
EN 55014-1:2006+A1: 2009+A2:
2011
EN 61000-3-2: 2006+A1:2009+A2:2009
EN 61000-3-3:2008
EN 55014-2: 1997+A1: 2001+A2: 2008
IEC 60335-1:2012
EN62233:2008
Producer Name
Apuro
Producer Address
15 Badgally Road
Campbelltown
NSW 2560
I, the undersigned, hereby declare that the equipment specified above conforms to the above Legislation and Standard(s).
Date 03/09/14
Sign
at
u
re
Full Name Richard Cromwell
Position Commercial Director
7
DM079-A_V3
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
Uniden UM525 Owner's manual
-
-
West Marine VHF650 Owner's manual
-
-
-
-
Uniden UM380 User manual
-
-
-