Protec Algo-Tec 6400 Quick start guide

Brand: Protec

Model: Algo-Tec 6400

Type: Quick start guide

PROTEC 6400 FIRE ALARM PANEL

In the event of a fire activation occurring the panel’s audible buzzer will commence

piping. The FIRE lamp will illuminate constantly and the ZONE location lamp will

illuminate.

The panel will also display the location details on the LCD display as follows:-

Comparing the zone number displayed on the

panel to the building zone plan will assist you

in identifying the location of the room/area in

detection to investigate

DETECTOR, CIRC A.0.100

ZONE 10

This part of the panel display is telling you that

a detector has activated in circulation area of

the building A.0.100 in zone 10

This part of the panel display is telling you that

only 1 device is in alarm

There are no faults

No parts of the alarm system are disabled

Pressing the enter button on the control panel

will allow you to view further information should

there be moor than I device in alarm

FIRE IN ZONE 10

SCHOFIELD LOOP 1 OP – HT

29 JULY 2008 12: 20:15

1 DEVICE IN ALARM

NO FAULTS

NO DISABLEMENTS TO VIEW

PRESS ENTER TO VIEW THE MENU

SILENCING FIRE EVENTS

After establishing the cause of the fire event confirming a false alarm

Using your panel key open the front cover to expose the function buttons

Press the ‘SILENCE’ key.

This will cause the ‘ALARMS SILENCED’ lamp to illuminate and the alarms to silence.

RESETTING FIRE EVENTS AFTER SILENCING THE ALARMS

Press the ‘RESET’ button.

Any fire indications will be extinguished.

Note

The fire condition will re-start if an automatic detector or manual call point remain active.

DEVICES LED LIGHT CONFIRMING THAT THEY HAVE BEEN ACTIVATED

SMOKE / HEAT SENSOR

Manual Call Point (MCP)

If the Red LED (Light) is illuminated constantly

on the smoke/heat sensor, it means that this

device has activated.

If the Red LED (Light) is illuminated on the

manual call point, the glass is most likely

to have been broken.

1
2
3
4

Protec Algo-Tec 6400 Quick start guide

Brand: Protec

Model: Algo-Tec 6400

Type: Quick start guide

Related papers

Other documents