Metra 88-00-9008 Operating instructions

Category
Projector lamps
Type
Operating instructions
Phillips Screwdriver • Radio Removal Tool
KIT FEATURES
Holds Three CD Jewel Cases
A)) Pocket Trimplate Assembly • B) (6) #6 x 1/4” Phillips Flat Head Screws
C) Brackets Set #1
KIT COMPONENTS
88-00-9008
POCKET PROVISION FOR ISO-DIN
OR STACKED-DIN MODELS OF VW
•GOLF 1999-2006 •GTI 1999-2005
•JETTA 1999-2005
(Excluding NEW JETTA 2005)
•PASSAT 2000-2005
B
C
TOOLS REQUIRED:
Applications
INSTALLATION INSTRUCTIONS FOR PART 88-00-9008
1-800-221-0932 www.metraonline.com
© COPYRIGHT 2001-2008 METRA ELECTRONICS CORPORATION Rev. 10-27-08
A
Phillips Screwdriver • Radio Removal Tool
KIT FEATURES
Holds Three CD Jewel Cases
A)) Pocket Trimplate Assembly • B) (6) #6 x 1/4” Phillips Flat Head Screws
C) Brac
kets Set #1
KIT COMPONENTS
88-00-9008
POCKET PROVISION FOR ISO-DIN
OR STACKED-DIN MODELS OF VW
•GOLF 1999-2006 •GTI 1999-2005
•JETTA 1999-2005
(Excluding NEW JETTA 2005)
•PASSAT 2000-2005
B
C
TOOLS REQUIRED:
Applications
INSTALLATION INSTRUCTIONS FOR PART 88-00-9008
1-800-221-0932 www.metraonline.com
© COPYRIGHT 2001-2008 METRA ELECTRONICS CORPORATION Rev. 10-27-08
A
"B"
"A"
88-00-9008
K
NOWLEDGE IS
P
OWER
Enhance your installation and fabrication skills by
enrolling in the most recognized and respected
mobile electronics school in our industry.
Log onto www.installerinstitute.com or call
800-354-6782 for more information and take steps
toward a better tomorrow.
Pull out on the plastic tray separating the dash cavity and remove the tray ("A").
Position the Pocket so each Bracket is configured with (2) screws on the top and (1)
screw on the bottom ("B"). Slide the Pocket into the dash opening until the side clips
engage.
ALL VEHICLES
"B"
"A"
88-00-9008
K
NOWLEDGE IS
P
OWER
Enhance your installation and fabrication skills by
enrolling in the most recognized and respected
mobile electronics school in our industry.
Log onto www.installerinstitute.com or call
800-354-6782 for more information and take steps
toward a better tomorrow.
Pull out on the plastic tray separating the dash cavity and remove the tray ("A").
Position the Pocket so each Bracket is configured with (2) screws on the top and (1)
screw on the bottom ("B"). Slide the Pocket into the dash opening until the side clips
engage.
ALL VEHICLES
  • Page 1 1
  • Page 2 2

Metra 88-00-9008 Operating instructions

Category
Projector lamps
Type
Operating instructions

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI