Electronic Cabinet Lock / ET924
Note: Please install batteries and set up key cards before installing the lock to cabinet.
Video about how to set up admin card and guest cards: https://youtu.be/
WyEsZhTCQVc
Features:
1. The cabinet wooden door should not exceed 1.2 inches thick
2. Multiple Unlock Mode: Single Unlock Mode, Dual Unlock Mode
3. 4 x AAA 1.5V batteries required
4. The batteries can last 8-12 months under normal use
5. The sound alarm will alert when the batteries power is low
6. The lock cannot be locked (keep open) if it is in low power status.
7. 1 admin card and up to 12 guest cards can be set up on this lock kit.
Operation Instructions
1. Reset
Install 4 x AAA 1.5V Batteries. Press the reset button shortly until single-beep sounds.
2. Select Unlock Mode (Single Mode is 1-card-swipe to unlock. Dual Mode is 2-card-swipes to unlock)
(1)Press the reset button shortly until you hear single-beep sounds. it is set in Single Mode.
(2)Press the reset button until you hear double-beep sounds, it is set in Dual Mode.
3. Set Up Admin Card
After resetting the lock, swipe a RFID card / tag. This first card / tag is configured as the admin card.
4. Set Up Guest Cards
Swipe the admin card and then swipe new cards one by one. These cards are added as guest cards.
5. Delete Cards
You can reset the lock if you want to delete the admin card and all guest cards.
6. Low Voltage Alarm
It requires 4x AAA 1.5V Batteries to power on. In low battery power status, when you swipe the card to unlock, the
voice alarm will alert (you can hear 8 beeps). And the lock cannot be locked (keep open). Please replace the batteries
to make the lock work again.
Package Includes:
1x Lock Body, 1x Latch, 1 set x Screws, 1 set x RFID Card/Tag, 1x Icon, 2x double-sided tape
If you have any question, please feel free to contact us by email: support@etekjoy.com