2. Anchor
  3. BIGFOOT

Anchor BIGFOOT Installation guide

  • Hello! I have reviewed the Bluetooth installation instructions for the 8,000 series 2 and Go Getter models. This document details the steps for installing a new Bluetooth module, including removing and connecting various harnesses and cables. I'm ready to answer your questions about the process.
  • What tools are required for the installation?
    What should I do before starting the installation?
    Which cables need to be connected to BT Audio?
    What color cables should be connected to BT only?
1
BLUETOOTH INSTALLATION
REQUIREMENTS:
•8,000 or series 2 Go Getter unit with I/O board at revision E (or newer)
•Screw drivers (Phillips #1 and #2)
•8 mm Nutdriver
INSTRUCTIONS:
1. Make sure the unit is powered off and the plug is disconnected.
INSTRUCTIONS:
2. Remove the screws around the back panel.
INSTRUCTIONS:
3. Remove the back panel.
INSTRUCTIONS:
4. Remove the battery harness.
INSTRUCTIONS:
5. Remove the low, medium, and high and speaker harness
a. If applicable please remove the mic receiver harness
INSTRUCTIONS:
6. Remove the internal power supply harnesses.
INSTRUCTIONS:
7. Remove the old Bluetooth module.
INSTRUCTIONS:
8. Remove the old harness from the Bluetooth module and use the included harnesses with the new Bluetooth module.
INSTRUCTIONS:
9. Connect the black and white audio cables to BT Audio.
INSTRUCTIONS:
10. Connect the red and black cables to BT only.
INSTRUCTIONS:
11. Reinstall the back panel to the unit and tighten with screws.
/