2. Starkrimson
  3. Duo-Trio
Duo-Trio

Starkrimson Duo-Trio Operating instructions

  • I have reviewed the instructions for the Starkrimson Duo and Trio amplifiers, which details power on procedures and notes concerning high voltage outputs. I'm ready to assist with any questions you have about these devices.
  • What should I do before powering on the amplifier?
    What happens if I turn on the amplifier without speakers?
    Can I connect the outputs to ground?
    What should I do before disconnecting?
    What will happen if I tamper with the device?
How do you like them apples?
Starkrimson® Duo/Trio Instructions
NOTES:
• Due to the bridged amplifier design, all speaker terminals are hot when the amplifier is on.
o Warning – High Voltage
o Do not connect any of the outputs to ground or earth.
• Do not power up or operate the amplifier without speakers connected to all channels.
• No user-serviceable parts – tampering with the amplifier will void the warranty.
To turn the amp on:
• Connect speakers to all channels
• Connect Inputs (XLR) on all channels
• Plug-in the power cord (switch must be in the off position)
• Turn the amplifier on by flipping the switch to the on position.
To turn the amp off:
• Turn it off by flipping the switch to the off position.
• Wait at least 15 seconds before removing any connections
Improper powerup or power down of the amps may cause damage and this damage will not be
covered under the warranty.
/