GM9000iED

GENMAX GM9000iED Operating instructions

  • I have reviewed the provided document about the GM9000iED generator neutral grounding cancellation instructions. This document provides detailed steps on how to disassemble the unit and cancel the bonded neutral grounding by disconnecting and insulating the white wire. I am ready to answer your questions about this device and procedure mentioned in the document.
  • What tool is needed to remove the bolts?
    What kind of screwdriver is needed to remove the screws?
    What should be done with the white wire after removing it?
GM9000iED Cancellation of Bonded
Neutral Grounding Instructions
2022.7.8
Disassemble and operate as the following
2.检查触发器插接头
有无松脱。
Use a wrench to
unscrew the two bolts
and nuts, and remove
the handle
Remove the 10 bolts
in the picture with an
8mm socket
Pull the front cover
from here by hand
Unscrew these 9 screws with a Phillips
screwdriver or electric gun and pull the
panel out some distance
View and operate from this
direction after pulling out the
panel find the terminal
block
Locate the bolts that hold the
white wire on the terminal block
and use a wrench to unscrew the
nut
Remove the white
wire terminal
Wrap the removed white wire terminal with
insulating tape, and then restore the unit to
complete the operation of canceling the
neutral grounding
/