Leitner LH470-475 User guide

  • Hello! I've reviewed the Quick Start Guide for your headset. This document explains how to connect your headset to a device, pair it, charge it, and use the travel clip. It also contains information on the FocusLight, which indicates the status of your calls. I'm ready to answer any questions you have about this device and its functions.
  • What does the flashing blue light on the headset indicate?
    What does a solid blue light on the headset indicate?
    What does a solid purple light on the headset indicate?
    What steps should be followed to repair device?
The integrated LED on your headset
flashes and changes color depending
on what your headset is doing.
1.
2. Press and hold the ON/OFF button
until the FocusLight flashes purple,
then release. Once it stops flashing,
press the ON/OFF button again to turn
the headset on.
For the full manual go to: leitnerheadsets.com/go Rapid response email: [email protected]
For full manual &
rapid setup
SCAN HERE
leitnerheadsets.com/go
Quick Start Guide
1. Plug the dongle into your computer
or tablet and wait for the device to
recognize the dongle (may take up to
a minute).
A
Note: If the dongle is unplugged for over 5
minutes, your headset will go to sleep. To wake
it up, follow the 2 steps above.
A
Connecting to your device
Incoming Call:
Flashing Blue*
Active Call:
Solid Blue
On Mute:
Solid Purple
FocusLight
*Requires compatible softphone or communication software
If your dongle is plugged in and the
headset is flashing red, they need to be
re-paired. Follow these simple steps:
Pairing
To charge your headset plug the USB cord
into the port on the side of the headset
and connect the other end to power.
Charge Level:
= Less than 15%
= 15% to 85%
= 85% to 100%
Charging
For the full manual go to: leitnerheadsets.com/go Rapid response email: [email protected]
Pairing & Charging
A
A
1. With the dongle plugged into your
device, press and hold the button on
the side of the dongle until the white
LED flashes once, then release. It will
continue to flash.
1.
2. Press and hold the ON/OFF button
until the FocusLight flashes blue once,
then release. The FocusLight will start
flashing purple. When the FocusLight
and the dongle LED stop flashing,
pairing is complete.
Travel Clip
The travel clip is a handy way to connect
the dongle to your headset while traveling.
The dongle slides into the travel clip and
then clips onto your headband.
/