Eglo 20557501 User manual

Brand: Eglo

Model: 20557501

Type: User manual

The Eglo 20557501 is a ceiling fan accessory designed for 40-degree sloped ceilings. It features a mounting bracket, canopy, hanger ball, and receiver shelf, and is suitable for fan blades that weigh up to 35 kg. The fan and hanging bracket must be earthed for safety. Please note that the downrod is not included and may need to be purchased separately.

Distributed by:

Reduction Revolution Pty Ltd

www.reductionrevolution.com.au

•

d capable of supporting a load of 35Kg, or 4 times th

r,,aged, an e

The fixing point for your ceiling fan must be of sound construction, unda . . . i h an . .

weight of the fi!Jn plus the method of attachment, whichever is greater· h fan blades to come into. contact w t Y obJect

Or surface.

Care needs to be taken to ensure the installation location does not a11°W t e d the nearest wall or obJect. Reduced clearances to Walls or

• ( d) an b·1·

There must be a minimum of 60cm clearance between the blade tiP en cause your fan to de-sta I ise. . ..

ceiling can not only reduce the amount of air your fan can move bUt also d the bottom of the blades. The ,nstallation should allow for

, f}ooran

The installation should also allow for a clearance of 2.lm between, the . •

; .

a minimum of 3.0m between ceiling fans.

The fan and the ha~ging bracket must be earthed.

. -:::

. . .

, .

@x1

c >

@x1

@x2

. .

Mounting Bracket

Canopy

Hanger ball

Hanger Ball Insert - 26.5mm downrods

Hanger Ball Insert- 21.0mm downrods

Hanger Ball Pin

Receiver Shelf ,

wood Screws & Washers

Important: When· mounted on anglei:J/sloped ceilings, the h'ttin.~ert,racket must be installed so that the opening.is facing across the

direction of ceiling pitch. This angle ceiling bracket mlfst only be 4led on a maximum 40 degree sloped ceiling pitch, and must have

a minimum of 60cm clearance from the lower side of.the ceiling t0t:he edge of the'fan blade. It would be expected that in many

installations, and extension downrod will nee'd to be purchased separately.

: '1ie1#:ing serews,,included are designed for use with t'lmbej ~ilimgj'(!)fs"ts, far afl other materials, t:he:.appropriate fixing

eeb' tm bepur9hased separately.

. ,......,, . -

if· ,· I · .:,..~··

. . , .:. . ·~· ....

min.

30mm

.& ._ I

' . . '

•

(G2.

\ '

Important: Select the correct size hanger ball insert Ci) or O ,

according to the diameter of the down rod on the fan being installed .

(

0 -1----Downrod

(Not lndued)

•

Note: Remove the hanger ball from your existing downrod assembly by

removing the screw, lowering the hanger ball, and removing the pin,

before sliding the hanger ball off the downrod.

' '

40 Deg. Canopy Ceiling Fan Accessory 2 J

Distributed by:

Reduction Revolution Pty Ltd

www.reductionrevolution.com.au

Eglo 20557501 User manual

Eglo 20557501 User manual

Other documents