\
•
•
1.
2.
3.
4.
'
d capable of supporting a load of 35Kg, or 4 times th
r,,aged, an e
The fixing point for your ceiling fan must be of sound construction, unda . . . i h an . .
weight of the fi!Jn plus the method of attachment, whichever is greater· h fan blades to come into. contact w t Y obJect
Or surface.
Care needs to be taken to ensure the installation location does not a11°W t e d the nearest wall or obJect. Reduced clearances to Walls or
• ( d) an b·1·
There must be a minimum of 60cm clearance between the blade tiP en cause your fan to de-sta I ise. . ..
ceiling can not only reduce the amount of air your fan can move bUt also d the bottom of the blades. The ,nstallation should allow for
, f}ooran
The installation should also allow for a clearance of 2.lm between, the . •
; .
a minimum of 3.0m between ceiling fans.
The fan and the ha~ging bracket must be earthed.
\
. -:::
. . .
, .
@x1
c >
©
0
@x1
@x2
A:
B:
C:
D:
E:
F:
G:
. .
H:
Mounting Bracket
Canopy
Hanger ball
Hanger Ball Insert - 26.5mm downrods
Hanger Ball Insert- 21.0mm downrods
Hanger Ball Pin
Receiver Shelf ,
wood Screws & Washers
Important: When· mounted on anglei:J/sloped ceilings, the h'ttin.~ert,racket must be installed so that the opening.is facing across the
direction of ceiling pitch. This angle ceiling bracket mlfst only be 4led on a maximum 40 degree sloped ceiling pitch, and must have
a minimum of 60cm clearance from the lower side of.the ceiling t0t:he edge of the'fan blade. It would be expected that in many
installations, and extension downrod will nee'd to be purchased separately.
: '1ie1#:ing serews,,included are designed for use with t'lmbej ~ilimgj'(!)fs"ts, far afl other materials, t:he:.appropriate fixing
eeb' tm bepur9hased separately.
. ,......,, . -
if· ,· I · .:,..~··
. . , .:. . ·~· ....
.
-
'
0
®
x2
min.
30mm
.& ._ I
I
' . . '
-
•
\
\
(G2.
0-
\
0
\ '
Important: Select the correct size hanger ball insert Ci) or O ,
according to the diameter of the down rod on the fan being installed .
(
0 -1----Downrod
(Not lndued)
•
•
0
Note: Remove the hanger ball from your existing downrod assembly by
removing the screw, lowering the hanger ball, and removing the pin,
before sliding the hanger ball off the downrod.
' '
'
4.
40 Deg. Canopy Ceiling Fan Accessory 2 J
