Step A
Step B
1 Lift the top plate of the stand until the top plate
(a) is in a 90° angle with the middle plate (b)
2 Turn both tablet supports at the same time (use both
hands)
Step C
3 Place the tablet supports in the tablet slots
Step D
4 Move the tablet supports so that they are clamped
around the middle plate. Your tablet stand is ready for use!
1
R-Go Riser Duo
Tablet stand
Instruction manual for tablet use
To set up the tablet stand, first
follow steps A, B and C on the other
side of the page.
a
b
2
90°
R-Go Riser Duo
Laptop stand
Instruction manual for laptop use
Step A
1 Open the document holder
2 Turn the whole stand
Step B
3 Grab the top and middle plate of the stand and leave
the bottom on the table and open the stand
1
2
Step C
4 Put the stand in the desired slot
of your height
3
4
Step D
5 Lift the top plate of the stand
6 Turn both laptop supports. Make sure that both
laptop supports are in a 90° angle to the top plate
7 Lower the top plate and make sure that both laptop
supports go into the laptop slot
5
6
7
7
Turn the page for
instructions on how to set
up as a tablet stand
-
1
-
2
R-Go r-go 741RD Riser Duo Tablet Stand User manual
- Type
- User manual
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Other documents
-
Toshiba M750 User manual
-
-
-
Genius 31731004100 Datasheet
-
-
-
Dell PowerEdge XE8545 Owner's manual
-
-
-