R-Go 741RD Riser Duo Tablet Stand, r-go 741RD Riser Duo Tablet Stand User manual

Hello! I've reviewed the instruction manual for the R-Go Riser Duo. This document provides steps on how to set up the stand for tablet and laptop use and describes the mechanism for how to extend and clamp the stand for use. I am ready to answer your questions about setting up and using this stand.
How do I set up the stand for tablet use?

How do I set up the stand for laptop use?

Do I need to use both hands to turn tablet supports?

Step A

Step B

1 Lift the top plate of the stand until the top plate

(a) is in a 90° angle with the middle plate (b)

2 Turn both tablet supports at the same time (use both

hands)

Step C

3 Place the tablet supports in the tablet slots

Step D

4 Move the tablet supports so that they are clamped

around the middle plate. Your tablet stand is ready for use!

R-Go Riser Duo

Tablet stand

Instruction manual for tablet use

To set up the tablet stand, ﬁrst

follow steps A, B and C on the other

side of the page.

90°

R-Go Riser Duo

Laptop stand

Instruction manual for laptop use

Step A

1 Open the document holder

2 Turn the whole stand

Step B

3 Grab the top and middle plate of the stand and leave

the bottom on the table and open the stand

Step C

4 Put the stand in the desired slot

of your height

Step D

5 Lift the top plate of the stand

6 Turn both laptop supports. Make sure that both

laptop supports are in a 90° angle to the top plate

7 Lower the top plate and make sure that both laptop

supports go into the laptop slot

Turn the page for

instructions on how to set

up as a tablet stand