2. TUFSKINZ
  3. TAC055 Tacoma Mud Flaps

TUFSKINZ TAC055 Tacoma Mud Flaps User manual

  • Hello, I'm your chat assistant. I've reviewed the Installation and Care Instructions for the Tacoma Mud Flaps (Front). The document includes details on tools needed, a step-by-step installation process and cautions for avoiding damage during installation. I'm ready to answer your questions about this document.
  • What tools are needed for installation?
    What is included with the mud flaps?
    Where are the factory screws located?
    What is the key caution during installation?
Installation and Care Instructions
Tacoma Mud Flaps(Front)
[email protected] @TUFSKINZ
Follow us on Instagram & Facebook
Please read all instructions before installation.
• Remove factory screws, see Figure 1 for location.
Figure 1
Questions or Support?
Contact:
REV: 1/07/20
• Attach the Long Screw with 2 spacers(Included), as seen in Figure 2 **Do not over tighten**
• Attach the remaining 2 factory screws, as seen in Figure 3 **Do not over tighten**
• Tighten each screw so it’s snug, be careful not to over tighten - Repeat steps for other side.
Figure 3
Figure 2
Attach Long Screw
and 2 spacers as
shown here:
Remove Factory
Screws as shown
here:
1. Tools and Materials Needed
•5/16” Socket Wrench
• 10mm Socket Wrench(For Factory screws)
• 2 - 2inch screws(Included)
• 4 - Spacers(Included)
2. Installation Preparation
3. Installation
/