IPLoA-MESH-PLC-W_Quick Start Guide_2017-11-20_Draft_2
1 2
43
65
7
8
IPLoA-MESH-PLC-W
Package Contents
Quick Start Guide
Overview
IPLoA-MESH-PLC-W User Guide
Technical information on DKT
HomeMesh family
1 pieces
IPLoA-MESH-PLC-W
You can now scan and connect to the Guide SSID, the default
Guide SSID is printed on the label of each IPLoA-MESH-
PLC-W.
The Power line diode will then shift
to Amber. Thats means that the unit
is ready for pairing with other units.
If the IPLoA-MESH-PLC-W can access
3rd party gateway or your Router
then the LAN LED will be Green slow
blinking (95% on/5% off).
The Wi-Fi LED should be Amber. That
means the Guide SSID is enabled.
Quick Start Guide
1 pieces
Installation of rst unit Installation of rst unit...
Installation of rst unit... Installation of rst unit...
Power Diode
LAN
Wi-Fi
1 x Gigabit Ethernet Ports
Pairing/Reset Button
Power Plugg (100V-240V~, 50/60Hz)
PDS Cable
(Ethernet)
All diodes will light up in
green for about 1 minute.
Router,
GateWay or
Modem
3.8s
on
0.2s
off
Amber
If the IPLoA-MESH-PLC-W can NOT access 3rd
party gateway or your Router then you are
not able to access the unit to complete the
installation.
Please see Troubleshooting guide.
IPLoA-MESH-PLC-W_Quick Start Guide_2017-11-20_Draft_2
Add the second unit
Add the second unit... Add the second unit...
Add the second unit... Adding further IPLoA-MESH-PLC-W
Please repeat step 11 to 13 to add further
IPLoA-MESH-PLC-W units
For further information and troubleshooting
please visit our web site
www.dktcomega.com
Factory Reset
Press pairing button more than 10 Seconds until
all the LEDs will be on, then release it.
Scan and join the Wi-Fi network
Use your laptop or smartphone to scan available Wi-Fi
networks.
Select the HomeMesh Wi-Fi network and input your
password.
You will now connect to the new mesh Wi-Fi network.
1.
Open your browser
and visit any web-
site, Web Guide
appers.
2.
Click on Create.
Choose new SSID
and Password.
3.
Follow the instruc-
tions on the login
screen.
Installation of rst unit...
The Power line diode will go green
rst and then shift to Amber. Thats
means that the unit is ready for pai-
ring with other units.
The LAN diode will be OFF
The Wi-Fi LED should be Amber.
Second
IPLoA-MESH-PLC-W
pairing button
First
IPLoA-MESH-PLC-W
pairing button
Trying to connect
1 sek1 sek
Connection established
The second unit will automatically
receive SSID from the rst unit
= OK
= OK
All diodes will light up in
green for about 1 minute.
9 10
1211
13 14
1615
/
