Page is loading ...
H5000
Deluxe Bedside
Assist Handle
Without
Legs
USER MANUAL - H5000 BEDSIDE HANDLE WITHOUT LEGS
GENERAL EXPLANATION OF YOUR BEDSIDE HANDLE WITHOUT LEGS
USER GUIDE
Prior to use please read all instructions.
We recommend you keep this User Guide in a safe place for future reference.
Please regularly check the bedside rail to identify areas of
potential entrapment, serious injury or death can occur if
the beside rail is not installed and positioned properly.
Adjust the beside rail so that it is tight against the mattress
with no gap at all time.
Place the bedside somewhere in between the headboard
and the footboard where users can easily reach.
The purpose of the bedside rail is to assist users who require
some assistance to move or sit up in bed, and need help with
balance when the person gets in and out of bed.
The bedside rail is not intended to use as prevention from
falling out of the bed at all time.
Handle height
adjustment button
Support Handle
Horizontal portion
slides in between
matress and
box spring
2
The bedside rail can be deformed under excessive force applied to it.
The bedside rail is only suitable for users who are under 300 lbs (135 Kg).
However, it is not intended to carry full weight of a person.
Narrow beds may remove Part 4 shown in Figure 1, if the beside rail
exceeds the other end of end. Please notice that in this case, the
beside rail may tilt if full body weight is applied to the beside rail.
Make sure to hear the click sound from the push bottom(s) each time
when assemble the bedside rail or adjust the Part 1 and Part 3 .
Please keep anyone (especially children) who's hanging on or playing
with the bedside rail.
SET UP
Insert the two end tubes of Part 1 into the two long end upright
tubes of the Part 2 at proper height.
Insert the two Part 3 into the two horizontal tubes of the Part 2.
Insert the two Part 4 into the two Part 3.
Insert the two ends of Part 5 into the two part 4.
Remove All Parts Shown in Figure 1 From the Box
OPERATION
WARRANTY
1
2
3
1
5
Lifestyle Mobility Aids company warrants all products for one year from the date of purchase from defects and craftsmanship.
The warranty does not cover wear and tear or misuse of the equipment. Lifestyle Mobility Aids company reserves the right if
an item needs to be warranted to replace or repair the item.
3
FIGURE 1
1
2
5
4
Once the bedside rail is assembled, it should look like Figure 2.
Please slide the horizontal portion which includes Part 3, 4,
and 5 in between the mattress and box spring.
After step 1, adjust the position of Part 1 to appropriate height
where user feels comfortable and needs the least effort to sit
up from bed. To adjust position Part 1, please notice that there
are push bottoms at each end of Part 1. When lowering, press
one bottom at one end and slightly lower the same end,
then push the other bottom and lower both end to the next
level. Likewise when rising Part 1, push one bottom and
slightly rise the same end, then push the other bottom and
rise both end to the next level.
Place Beside Rail Accordingly
2
1
FIGURE 2
OPERATIONS
3
4
Some Additional Products:
/
