BUNN
®
practices continuous product research and improvement. We reserve the right to change specifications and product design without notice. Such
revisions do not entitle the buyer to corresponding changes, improvements, additions or replacements for previously purchased equipment.
All dimensions shown in inches.
Dimensions & Specifications
Bunn-O-Matic
®
Corporation - 1400 Stevenson Drive Springfield, Illinois 62703 • 800-637-8606 • 217-529-6601 • Fax 217-529-6644 • www.bunn.com
Model Product # Volts Amps Tank Heater Total Brewing Cu. Shipping Cord
Watts Watts Capacity Ft. Weight Attached
SRU 06325.0001 120/208 19.4 3950 4025 11.4 gal./hr. 3.1 73 lbs. No
SRU 06325.0002 120/240 17.0 3950 4025 11.4 gal./hr. 3.1 75 lbs. No
Brewing capacity: based upon incoming water temp of 60ºF (140ºF rise).
Models listed as 120/208V or 120/240V must be connected to 208V or 240V electrical service respectively. Please refer to the installation manual.
Electrical: Models require 3-wires plus ground service, single phase, 60 Hz.
Plumbing: 20-90 psi (138-621 kPa). Supplied with
3
⁄
8
" OD male flare fitting.
SWING SPOUT
FOR WATER
BYPASS OPTION
CLEAN OUT
PORT COFFEE
FAUCET
ONLY
3.6
(STD FAUCET
SHANK)
HALF BATCH
SWITCH (STD)
4.0 ADJ LEG (OPTIONAL)
33.5
WITH
FEET
10.9
1.5
1.4
1.9
14.4
LIGHTED ON/OFF
SWITCH (STD)
OR
LIGHTED ON/OFF/START
SWITCH W/BREW
TEMPERATURE
LOCKOUT (OPTIONAL)
14.2
MOMENTARY START
SWITCH (STD)
OR
READY INDICATOR LAMP
W/BREW TEMPERATURE
LOCKOUT (OPTIONAL)
8.0
(EXT)
OVERFLOW
FITTING
9.7
10.3
11.8
1.4
4.0
14.0
POWER SUPPLY
CONNECTION
HEX UNION
NUT (SHOWN)
7.0" SIGHT GAUGE
W/SHUT-OFF VALVE
(COFFEE)
4.0" SIGHT GAUGE
W/SHUT-OFF VALVE
(HOT WATER)
3.0 (EXT)
1.75 ADJ
4.1
.3
37.3
WITH
LEGS
(OPTIONAL)
WATER SUPPLY CONNECTION
(.375 OD TUBE 45˚ FLARE)
19.1
24.6
14.4
10/09 © Bunn-O-Matic Corporation