2. Home
  3. Domestic appliances
  4. Climate control
  5. Fireplaces
  6. Drolet
  7. ESCAPE 1800-I WOOD INSERT
ESCAPE 1800-I WOOD INSERT

Drolet ESCAPE 1800-I WOOD INSERT Assembly Instructions

  • Hello! I am an AI chatbot trained to assist you with the Drolet ESCAPE 1800-I WOOD INSERT Assembly Instructions. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
45813A
Printed in Canada 04-06-2015
32'' x 50'' CUTTABLE FACEPLATE
AC01357
INSTALLATION INSTRUCTIONS
Stove Builder International inc.
250, rue de Copenhague
Saint-Augustin-de-Desmaures Quebec, Canada G3A 2H3
2
Faceplate installation
Note: The illustrations may vary from one model to another, but the method of assembly
remains the same.
CAUTION: THE MATERIAL MAY BE SHARP WHEN HANDELLED. WEAR GLOVES
AND SAFETY GLASSES BEFORE HANDLING OR CUTTING THE FACEPLATE.
1
Remove the faceplate (A) from its box. Then remove the faceplate extension (B), provided
with the appliance, which is secured between the firebox and the convection air jacket of
the insert.
Place the faceplate panels with the finished side down on a flat, soft, non-abrasive surface
and follow the installation instructions below;
Hardware included with the faceplate:
4X - #10-24" x 1/2" bolts
4X - #10-24" hex nuts
3
2
Center the insert into
the fireplace opening
and then trace the
outline of the desired
shape on the faceplate.
Note: Making a
template may be useful
prior to cutting of the
faceplate
Cut using metal snips.
3
Align the holes in the
faceplate extension with
the holes in the
faceplate and secure
both assembly together
using four bolts (C) and
nuts (D) provided.
Note: If the installation of a heat radiation shield is required to reduce clearances from the
shelf and upper surround, refer to Appendix: Optional Top Surround and Shelf Heat
Shield Installation (AC01317) of your appliance manual prior to the installation of the
faceplate on the insert.
4
4
Align the notch in the faceplate extension with the bolt (E) welded to the air jacket and slide
the faceplate assembly just over the washer (F) and bolt’s head (G). Then push towards
the fireplace.
If necessary, adjust the height of the insert using the leveling bolts on each side of the
convection air jacket so that the faceplate is properly seated on the floor of the hearth
extension.
Once the faceplate is in place, secure the assembly by tightening nut (G) using a 7/16"
(11 mm) open end wrench.
/